ACASIS M03 User manual

www.acasis.com
Dual NVME M.2 SSD Docking Station
User Manual
Modle:M03

www.acasis.com
Product Features
Clone Button
Clone Process LED Indicators
Target SSD SLOT
Work LED Indicator
Source SSD SLOT
Work LED Indicator
Type-C
Power Port
Power Button
1
2
3
4
5
6
7
8
9
1
Compatible with PCI-e NVMe M.2 M key & B+M key SSDs
NOT COMPATIBLE with M.2 SATA / AHCI SSDs
Read from and write to both SSDs simultaneously
Support data transmission speeds of up to 10Gbps
Offline cloning without using a computer
Full aluminum construction for maximum heat dissipation
100% tool-free design
Support Windows 7 or higher / Mac OS 10.5 or higher /
Linux Kernel 2.4 or higher.

Package Contents
www.acasis.com
SSDs Read/Write Installation Instruction
2
Dual NVME M.2 SSD Docking Station
USB-C to USB-A cable
USB-C to USB-C cable
Power adapter 5V/4A
User Manual
Plug the SSDs into the SLOT.
Connect the power adapter.
Connect the USB cable with the computer.
Press the power button and start to use.
WARNING: Do not install any disks while the device is powered on
or connected to the computer's USB port.

www.acasis.com
3
Off-line Disk Cloning Instruction
Insert your source SSD in SLOT A
Insert your target SSD in SLOT B
Connect the power adapter to the enclosure.
Press the power button.
Press and hold down the clone button for 3 seconds until the
LED indicator begins to flash.
The LED indicators show the cloning progess.When all four LEDs
stops flashing, the cloning process is finished. This process may
take a long time which mainly depends on the capacity of SSD.
1
2
3
4
5
6
Before cloning, disconnect the USB cable from the enclosure.
Comfirm that the capacity of target SSD is equal or greater than
the source SSD, otherwise the cloning function will not work.
source Target

www.acasis.com
4
Off-line Cloning Trouble Shooting
Why the target drive doesn‘t show up?
Depending on your operating system, your
newly cloned drive may not show up.
This happens because there is a signature collision between
the drives after they are cloned. As a consequence, the target
drive goes offline.
For Windows 7 or higher :
1) Right-click [ This PC ] -> Click [ Management ] -> Click [ Disk
Management ].
2) Right-click the offline drive to open the context menu,
then click [ Online ].
3) The target drive will come back online, and both
drives share the same name.

www.acasis.com
5
Why there is unallocated space in cloned disk?
If the capacity of target drive is bigger than the source drive,
the remainder of the drive space will be left as unallocated
space.
1) Open Disk Management, Right click on the unallocated
partition of your newly cloned drive.
2) Click [Extend Volume�] in the pop up menu
3) Following the steps of New Simple Volume Wizard to assign
the unallocated partition.
How to make it available for data storage?
Email: [email protected]
Website: https://www.acasis.com
Official Store: https://shop.acasis.com
Facebook Page: https://www.facebook.com/Acasis.support
Acasis Club: https://www.facebook.com/groups/acasis