
8FU.BU¥**
Data sheet
Page 3
Cleaning:
Regular cleaning will maintain both the effectiveness and lifespan of 8FU.BU¥** has both anti-bacterial and anti-fungal additives to protect
against fungal and bacterial contamination, but regular cleaning is also recommended to remove light grease and oils,food fat, wax and acrylic
polishes.
PREPARATION
'LIGOXLIQEXXMRKMWJVIIJVSQER]PSSWIMXIQWPMOIVYFFMWLERHGPSXLMRKGJCFST
HAND CLEANING
Regular hand cleaning should be done as required, using an EPOEPMRIGPIERMRKJPYMH as per the manufacturer’s instructions. The matting can be
cleaned in position – simply apply the cleaning solution with a sprayer or mop and allow to penetrate any grease or dirt. You can then use a
stiff HIGOFVYWLXS[SVOXLIGPIERMRKJPYMHMRXSXLIWYVJEGIHMVX%PPS[XSWSEOFIJSVIVMRWMRK[MXLGPIER[EXIV
-J]SY´VIHIITGPIERMRKSVGPIERMRKXLIJPSSVMRKFIPS[XLIQEXWWLSYPHFIVSPPIHYT8LI]WLSYPHR´XFIJSPHIHSVTYPPIHSVHVEKKIHEWXLMW[MPP
damage the matting over time.
MACHINE CLEANING
,S[JVIUYIRXP]]SYQEGLMRIGPIER[MPPHITIRHSRLS[QYGLXVEJJMGXLIEVIEKIXW7TVE]XLIWYVJEGI[MXLXLIEPOEPMRIWSPYXMSRERHXLIRYWMRKE
cylindrical brush machine, clean the top surface in the direction of the top ribs. If there’s an etched pattern on the top ribs where dirt can easily
collect, make additional cross passes to ensure a thorough clean.
If the underside of the matting also needs a clean, roll it up and then roll back out, leaving the underside facing upwards. Repeat the spray and
above cleaning instructions.
STEAM CLEANING
Any type of steam cleaner can be used. Good results have been obtained with nozzle pressure of approximately 1000 lbs p.s.i. (6894.8 kN/m²)
ERH[EXIVXIQTIVEXYVISJETTVS\MQEXIP]*'PIERMRKJPYMHWLSYPHFIHMPYXIHEGGSVHMRKXSXLIQERYJEGXYVIV´WVIGSQQIRHEXMSR
Installation:
:HW0DWVone-piece construction means installation is simple:
•1EHIJVSQ¾I\MFPI4:'
•Supplied in rolls for quick installation
•)EW]XSGYXXS½XSRWMXI
•Contours to uneven surfaces