Invacare Corporation
www.invacare.com
USA
One Invacare Way
Elyria, Ohio
44035-4190
(800) 333-6900
Canada
570 Matheson Blvd. E.
Unit 8
Mississauga, Ontario
L4Z 4G4 Canada
(800) 668-5324
“Invacare says
‘Yes, you can.
®’ and I
couldn’t have said it
better myself.’’
Invacare, the Blue Medallion
Design, Yes, you can., the TT
Design and Tarsys are
registered trademarks and
Ranger X, Anything else is a
compromise, MKIV and GB are
trademarks of Invacare
Corporation. Invacare Virtual
Service is a service mark of
Invacare Corporation. Monroe
is a registered trademark of
Tenneco Automotive Inc.
Specifications are subject to
change without
notification.
Patent pending.
© 2005
Invacare Corporation
Form No. 00-315
Rev. 12/05
Invacare® Storm Series®Ranger X™ Power Wheelchair
Invacare®Storm Series® Ranger X™ Power Wheelchair
ANSI/RESNA W/C 19 sec 6.2 Presale Literature Notification – Storm Series®Ranger X™
Adjustable ASBA Rehab Seat design meets the widest range
of changing consumer needs.
•Adjustable angle back offers a range of 85º to 105º
•Width is adjustable in 1" increments in the following
ranges: 12"-16", 16"-20", 20"-24"
•Depth is adjustable in 1" increments in the following
ranges: 12"-18", 16"-19", 19"-22"
•Manual recline option is available
TARSYS®Powered Seating Systems can be added easily as
more rehab options are needed
•Offers Tilt, Recline, Tilt/Recline, Power Tilt Only,
Elevating Seat or PTO/Elevating Seat
•Seat location system allows for the seat to slide along
the base frame to optimize the center of gravity while
maintaining traction and stability
Storm Series®drive wheels can be adjusted forward or
rearward for maximum maneuverability and precise center-of-
gravity adjustment
Seating & Positioning Flexibility
Maximum speed
4-pole motor (standard) 6 mph
GB with TrueTrack motor (standard) 7 mph
Dimensions
Weight capacity
4-pole motor w/MKVIA electronics 300 lb.
With tilt/recline 250 lb.
GB motor (optional) 400 lb.
With tilt/recline 350 lb.
Overall base width (with 14'' x 3'' wheels)
4-pole motor (standard) 25''
GB with TrueTrack motor (optional) 24.75''
Seat-to-floor height (at 0° tilt)
Low 17.5''
Medium 19.5''
Tall 21''
Overall base length*
Short base 28.5''
Long base 31.5''
Seat adjustability
Width (1'' increments) 12'' to 22''
Depth (1'' increments) 12'' to 22''
Back angle (5° increments) 85° to 105°
Seat tilt (continuous adjustment) 0° to 10°
Arm height
Fixed 10''
Adjustable 9.5'' to 13.5''
Specifications
Drive wheels
Pneumatic (standard) 14'' x 3''
Foam-filled (optional) 14'' x 3''
Pneumatic and foam-filled** (optional) 14'' x 4''
Fee-wheel hub with HD 4-pole motor (optional)
Casters
Semi-pneumatic (standard) 8'' x 2.25''
Pneumatic (optional) 8'' x 2.5''
Pneumatic and foam-filled (optional) 9'' x 3''
Caster suspension (optional)
Pneumatic and semi-pneumatic 8''
Electronics
MKIV™A with switch options (standard)
Batteries***
Group 24 (standard)
Weight (18" x 18" seat size with Group 24
batteries and without front riggings) 266 lb.
* Measured from head tube to standard anti-tip wheel.
** 14" x 4" adds 2" to overall width. Not available with TrueTrack.
*** Sealed gel cell recommended.
Accessories
Alternative seating
2G tilt, recline and combination
Manual reclining back
Power-elevating legrests
Ventilator tray
A. Minimum turning radius 31.9"
Minimum turn-around width 63.8"
B. Ranger X wheelchairs have a maximum length of 41.5" inches
or 1054 mm, meeting the ADA definition of a common
wheelchair and the minimum length requirements of lifts on
public vehicles.
C. Total wheelchair mass = 296 lb. (134 kg) – including front
riggings, wheel locks, TRO brackets, wheelchair-anchored
pelvic belt, and seating.
D. Average lateral dummy displacement = approximately .48"
(12l.3mm)
E. Overall Score = 20 Overall Rating = A
F. i. The Ranger X tested was sized to accommodate a 168 lb.
test dummy (17"x17"x 18" high and 14" Rear-Wheel Drive
tires).
ii. The Ranger X was tied down using four tie-down brackets
– 2 brackets located on the front of the base frame and 2
brackets located on the rear of the base frame.
iii. The Ranger X was tested with a 168 lb. test dummy.
iv. The Ranger X tested used a wheelchair-anchored pelvic
belt and vehicle-anchored shoulder belt.
v. The Ranger X tested complies with the performance
requirements of ANSI/RESNA W/C 19 sec. 5.3.
G. For all types of vehicles, the Torque SP requires four SAE J2249-
compliant tie-down strap assemblies for effective securement.
H. The Ranger X provides a location for anchoring of an Invacare-
provided pelvic belt. This belt has been tested in accordance
with ANSI/RESNA W/C 19.
I. The wheelchair-anchored pelvic belt is supplied by Invacare.
