equipment generates, uses, and can radiate radio frequency energy. If the equipment
is not installed and used in accordance with the instructions, the equipment may cause
harmful interference to radio communications. There is no guarantee, however, that
such interference will not occur in a particular installation. If this equipment does cause
harmfulinterference toradioortelevisionreception(whichcan be determinedbyturning
the equipment off and on), the user is encouraged to try to correct the interference by
taking one or more of the following measures:
- Reorient or relocate the receiving antenna of the equipment experiencing the
interference.
-Increase the distance between the wireless adapter and the equipment experiencing
the interference.
- Connect the computer with the wireless adapter toanoutlet on a circuit different
from thatto which the equipment experiencing the interference is connected.
-Consult the dealer or an experienced radio/TV technician for help.
Caution: Changes or modifications not expressly approved bythe party
responsible forcompliance could void the user’s authority to operate the
equipment.
High power radars are allocated as primary users of the 5.25 to 5.35 GHz and 5.65
to 5.85 GHz bands. These radar stations can cause interference with and/or damage
this device. No configuration controls are provided for thiswireless equipment
allowing any change in the frequency of operations outside the FCC grant of
authorization for US operation according to Part 15.407 of the FCC rules.
FCC RF exposure information (SAR)
This device meets the government's requirements for exposure to radio waves. This
device is designed and manufactured not to exceed the emission limits for exposure to
radio frequency (RF) energy set by the Federal Communications Commission of the
U.S. Government.
The exposure standard for wireless devices employs a unit of measurement known as
the Specific Absorption Rate, or SAR. The SAR limit set by the FCC is 1.6 W/kg. Tests
forSARareconductedusing standard operating positionsacceptedby theFCC withthe
device transmitting at its highest certified power level in all tested frequency bands.
Althoughthe SARisdeterminedatthehighestcertifiedpowerlevel,theactualSARlevel
ofthedevicewhileoperating canbewellbelowthemaximum value. This isbecause the
device is designed to operate at multiple power levels so as to use only the poser
required to reach the network.
In general, the closer you are to a wireless base station antenna, the lower the power
output. While there may be differences between the SAR levels of various devices and
at various positions, they all meet the government requirement.
The FCC has granted an Equipment Authorization for this device with all reported SAR
levels evaluated as in compliance with the FCC RF exposure guidelines. SAR
information on this device is on file with the FCC and can be found under the Display
Grant section of www.fcc.gov/oet/ea/fccid after searching on FCC ID for your device.
Canada – Industry Canada (IC)
This device complies with RSS247 of Industry Canada. Cet appareil se conforme à
RSS210 deCanada d'Industrie.
This device complies with Industry Canada license-exempt RSS standard(s).
Operation is subject to the following two conditions: (1) this device may not cause
interference,and(2)thisdevicemustacceptanyinterference,includinginterferencethat
may cause undesired operation of the device.
Ce dispositif est conforme a la norme CNR-247 d'Industrie Canada applicable aux
appareils radio exempts de licence. Son fonctionnement est sujet aux deux conditions
suivantes: (1) le dispositif ne doit pas produire de brouillage prejudiciable, et (2)ce
dispositif doit accepter tout brouillage recu, y compris un brouillage susceptible de
provoquer un fonctionnement indesirable.
- Radiation Exposure Statement:
The product comply with the Canada portable RFexposure limit set forth for an
uncontrolled environment and are safe for intended operation as described in this
manual.
The further RF exposure reduction can be achieved if the product can be kept as far as
possible from the user body or set the device to lower output power if such function is
available.
Déclarationd'expositionauxradiations:Leproduitestconformeauxlimitesd'exposition
pour les appareils portables RF pour les Etats-Unis et le Canada établies pour un
environnement non contrôlé.
Le produit est sûr pour unfonctionnement tel que décrit dans ce manuel. La réduction
aux expositions RF peut être augmentée si l'appareil peut être conservé aussi loin que
possible du corps de l'utilisateur ou que le dispositif est réglé surla puissance de sortie
la plusfaible si une telle fonction est disponible.
This Class B digital apparatus complies with Canadian ICES-003.
Cet appareil numérique de laclasse B est conforme a la norme NMB-003 du Canada.
"To prevent radio interference to the licensed service, this device is intended to be
operatedindoorsand awayfromwindowstoprovidemaximumshielding. Equipment (or
its transmit antenna) that is installed outdoors issubject to licensing."
«Pour empêcher que cet appareil cause du brouillage auservice faisant l'objet d'une
licence,ildoitêtre utilisé a l'intérieuret devrait êtreplacéloindesfenêtresafinde fournir
un écran de blindage maximal. Si le matériel (ou son antenne d'émission) est installé à
l'extérieur, il doit faire l'objet d'une licence. »
(Notice for 5GHz)
Caution:
(i) the device for operation in the band 5150 - 5250 MHz is only for indoor use to reduce
the potential for harmful interference to co-channel mobile satellite systems;
(ii) the maximum antenna gain permitted for devices in the bands 5250 - 5350 MHz and
5470 - 5725 MHz shall comply with the e.i.r.p. limit: and
(iii) the maximum antenna gain permitted for devices in the band 5725 - 5825 MHz shall
comply withthee.i.r.p.limits specified for point-to-pointandnon point-to-pointoperation
as appropriate.
(iv) Users should also be advised that high-power radars are allocated as primary users
(i.e. priority users) of the bands 5250 - 5350 MHz and 5650 - 5850 MHz and that these
radars could cause interference and/or damage to LE-LAN devices.
Exposure of humans toRF fields (RSS-102)
The computers employ low gain integral antennas that do not emit RFfield inexcess of
Health Canada limitsfor the general population; consult Safety Code 6,obtainable from
Health Canada's Web site at http://www.hc-sc.gc.ca/
The radiated energy from the antennas connected to the wirelessadapters conforms to
the IC limit of the RFexposure requirement regarding IC RSS-102, Issue 4 clause 4.1.
SAR testsare conductedusingrecommended operatingpositionsaccepted bytheFCC/
RSSwiththedevicetransmittingatitshighestcertifiedpowerlevelinall testedfrequency
band without distance attaching away from the body. Non-compliance with the above
restrictions may result in violation of FCC RF exposure guidelines.
Conformité desappareils de radiocommunication aux
limites d'exposition humaine aux radiofréquences
(CNR-102)
L'ordinateur utilise des antennes intégrales à faible gain qui n'émettent pas un champ
électromagnétique supérieur auxnormes imposées par Santé Canada pour la
population. Consultez le Code desécurité 6 sur lesite Internet de Santé Canada à
l'adresse suivante : http://www.hc-sc.gc.ca/
L'énergie émise par les antennes reliées aux cartes sans fil respecte lalimite
d'exposition aux radiofréquences telle que définie par Industrie Canada dans la clause
4.1 du document CNR-102, version 4.
TestsDASsont effectuésenutilisantles positionsrecommandéesparlaFCC/CNRavec
le téléphone émet à lapuissance certifiée maximale dans toutes les bandes de
fréquencestestées sans distanceattacher loindu corps.Non-respect des restrictionsci-
dessus peut entraîner une violation des directives de la FCC/CNR.
Brazil
Esteequipamentooperaemcarátersecundário,istoé,nãotemdireitoaproteçãocontra
interferência prejudicial, mesmo de estações do mesmo tipo, e não pode causar
interferência a sistemas operando em caráter primário.
Mexico
Cofetel notice is:
“Laoperaciondeesteequipoestasujetaa lassiguientes doscondiciones:(1)esposible
que este equipo o dispositivo no cause interferencia perjudicial y (2) este equipo o
dispositivo debe aceptar cualquier interferencia, incluyendo la que pueda causar su
operacion no deseada.”
SAR information
RF exposure information (SAR)
This device meets the EU requirements (1999/519/EC) on the limitation of exposure of
the general public to electromagnetic fields by way of health protection. The limits are
part of extensive recommendations for the protection of the general public. These
recommendations have been developed and checked by independent scientific
organizations through regular and thorough evaluations of scientific studies. To
guarantee the safety of all persons, regardless of age and health, the limits include a
significant safety buffer. Before radio devices can be put in circulation, their agreement
with European laws or limits must be confirmed; only then may the CE symbol be
applied.
The unit of measurement for the European Council's recommended limit for mobile
devices is the "Specific Absorption Rate" (SAR). This SAR limit is 2.0 W/kg, averaged
over 10 g of body tissue. It meets the requirements of the International Commission on
Non-Ionizing Radiation Protection (ICNIRP). The maximum SAR value is calculated at
the highest output level in all frequency bands of the mobile device. The highest SAR
value reported under this standard during product certification for use of the device at
a distance of 0 cm from the body.
During use, the actual SAR level is usually much lower than the maximum value,
becausethemobiledeviceworksindifferentoutputlevels.Itonlytransmitswithasmuch
output as is required to reach the network. In general the following applies: The closer
you are to a base station, the lower the transmission output of your mobile device.
