Acuity AQ9900008 Installation guide

1
8” Touch Panel Display System
Hardware Overview Guide (P/N:AQ9900008)
[e-mail]
Tel: [phone]
Fax: [phone]
acuitylaser.com
©2022 Schmitt Measurement Systems
2765 NW Nicolai St.
Portland, OR 97210 USA

2
1. Setup
1.1. When ordering the (AQ9900008) TPD, for hardware, you will receive the touch panel display,
TPD power supply, and (4) mounting screws.
1.2. Connect the laser connection kit(s) to the port(s) on the left and/or right side of the TPD with a
DB-9 cable. Ensure the laser is powered up. When using a single laser, please use port A if
possible.
1.3. Connect the power cable to the TPD and a power source. Power cable port located on bottom
of unit.
Left Side - Serial Ports
Right Side - Serial Ports
Power Button
Bottom Side - Power Cable

3
1.4. Power up the TPD by pushing the silver button on the top left side of the TPD. The power
indicator on the front of the TPD will light up blue.
1.5. Upon initial power up, the TPD will boot into the Settings screen after approximately 30
seconds. Please see the software manual for further instructions on best operating the TPD
software.
Power Button