Ada Ez Pro Series User manual

700503
Rev. A, 05/23/13
© 2012 ADA EZ. ALL RIGHTS RESERVED. 1 of 2
ADA EZ Pro
Hardwire Instructions
700503 Rev A 05-23-13
1.1 Installing the Optional Plug-In Transformer
NOTE
An optional plug-in transformer is recommended in installations where the automatic door-opening feature
will be used frequently and is required if the Power Close or Push and Go fetures are activated.
1.1.1 Route the extension wire from the wall outlet to the frame of the door.
1.1.2 Refer to Figure 1, and mount one door cord bracket to the face of the door behind the
battery pack , mount the other door cord bracket to the frame of the door using the
supplied mounting screws.
Figure 1. Installing the Optional Plug-In Transformer

700503
Rev. A, 05/23/13
© 2012 ADA EZ. ALL RIGHTS RESERVED. 2 of 2
1.1.3 Refer to Figure 2 and plug in the power connector.
1.1.4 Refer to Figure 2 and install the battery wire cap.
1.1.5 Plug the transformer into the wall outlet and plut the extension into the transformer.
1.1.6 Refer to Figure 2 and ensure the switch on the battery pack is set to the “ON” position.
Ensure the LED lights steady green. If the light does not light steady green, reverse the
wires on the power connector.
Figure 2. Install Connector and Battery Cap