ADC e-sphyg 3 User manual

Quick Start Guide
Charge the battery before using for the first time.
Select the appropriate power plug and connect to the power
adapter as shown. Plug into power adapter socket at back
of unit and plug into wall outlet. Charge battery until
recharge indicator on main unit turns green.
Charge the Battery
Connect one end of the extension BP hose to the E3 as shown.
Connect the appropriate cuff to the hose metal connector,
by pushing the male bayonet on the cuff hose into the
receiver on the extension hose.
When properly seated the male bayonet will snap into place.
To release, slide the outer sleeve of the receiver back.
Select and Connect the Cuff
1
2
Press On/Off switch at back of unit to power on.
The unit will beep twice, the display will illuminate, and the unit
will perform a self check. If an error message appears, do not
use and contact ADC.
The unit will display a “0” when ready for measurement.
Turn the Unit On
3
Apply the cuff to the patient’s upper arm. Align the artery mark
with the patient’s brachial artery.
Ensure the cuff is correctly sized for the patient –
the index line should fall between the range lines.
If it does not, select a larger or smaller cuff as indicated.
Apply the Cuff
4
Left Arm
Tube
Index Line
This side against limb
Select Smaller Cuff Correct Cuff Size
佣 佣
Select Larger Cuff
佣

By default, inflation pressure is set to auto.
If you wish to change the pressure:
1) Press and hold the Memory Button for three
seconds until the column with pressure
values flashes.
2) Press the Start/Stop Button to cycle through
the pressure values until you’ve highlighted the one you want.
3) Press the Memory Button to confirm and set the new value.
Once max pressure is set, press the Start/Stop Button to begin a single measurement.
Unit will display and store reading when measurement is completed.
Set Maximum Inflation Pressure
in Single Measurement* Mode
5
• Allow the patient to sit quietly for two to five minutes before measurement.
• Use the proper size cuff; if two cuff sizes fit, use the larger one.
• Place the cuff on a bare arm.
• Position the artery mark over the brachial artery.
• Apply the cuff snugly, allowing room for no more than two fingers between
the cuff and patient’s arm.
• Support the patient’s back and feet; keep legs uncrossed.
• Keep the upper arm at heart level with the lower arm passively supported
(e.g., resting on lap).
• Keep the arm still during the measurement cycle.
• Do not talk to the patient while taking a blood pressure reading.
For Best Results
Download full manual at www.adctoday.com/esphyg3
6
Push and hold for
3 seconds...
American Diagnostic Corporation
55 Commerce Drive
Hauppauge, NY 11788 USA
1-800-ADC-2670
www.adctoday.com
Push to change
value
Press to confirm
new value
*Consult the complete Instructions for Use for information on changing to and using manual
mode or the programmable average mode. Visit www.adctoday.com/esphyg3.
IFU p/n: 93-9003QS-00 rev 0 (11/6/2019)