ADDONICS TECHNOLOGIES
Model: DGC3DVD-SC
Quick Guide
I. Overview
There are four buttons and an LCD on the panel of DigiCopier.
1 –LCD shows a function or a message.
2 –it is used to scroll up function menus.
3 –it is used to scroll down function menus.
4 –it is used to execute a function.
5 –it is used to cancel a function.
II. Connecting the power cable and turning on the
DigiCopier
a. Connect the power cord provided from the wall outlet to the
back of the DigiCopier.
b. A main power switch is located at the back of the tower. Turn
the switch on. Another auxiliary power switch is located on
the front of the tower.
III. Steps for the Copying Process
Note: may not able to copy-protected DVD or CD.
Step 1 Turn on the DigiCopier by pressing the auxiliary power
switch.
Step 2 Insert media you wish to duplicate into the source tray on
the top.
Step 3 Populate the destination trays with blank CDs or DVD
media. A rewritable DVD containing old data can also be use, but
the old data will be automatically erased.
Step 4 After the DVD-ROM and DVD writers detect DVDs, press
ENT button to start copying.
LCD will show the copying information as follows.
When copying is in progress, MB and time will decrease while
the percentage of completion will increase. “MB” means the size
of data that you want to copy.
When copying comes to an end, LCD will show the results as
follows. The DVDs that were successfully copied will eject
automatically.
The complete user manual of the DVD Duplicator can found in
the Driver Disk under User Guides or can be downloaded from
http://www.addonics.com/support/user_guides/
TECHNICAL SUPPORT
Email: http://www.addonics.com/sales/query/
Internet: http://www.addonics.com
Technical Support (8:30 am to 6:00 pm PST)
Phone: 408 453-6212
Email: http://www.addonics.com/support/query/
