Addonics Technologies REDESP? REDESPU3 User manual

T E C H N O L O G I E S
User Guide
Ruby eSATAp ExDrive
(REDESP, REDESPU3)
Installing your HD to the
Ruby eSATAp ExDrive
Step 1
Separate the top from the bottom cover of
the drive enclosure by loosening the screw.
Step 3
Wrap the shock absorbers around
the hard drive and PCB.
Switch
SATA Connector
PCB
Shock Absorbers
HD Step 2
Align the SATA connector in the
2.5” hard drive with the SATA
connector on the PCB.
Step 4
Turn over the PCB and secure the hard
drive to the PCB with the mounting
screws that come with the kit.
Bottom of PCB
Technical Support
If you need any assistance to get your unit functioning properly, please have your
product information ready and contact Addonics Technical Support at:
Hours: 8:30 am - 6:00 pm PST
Phone: [phone]
Email: http://www.addonics.com/support/query/
v3.1.11
www.addonics.com

Step 5
Mount the board to the bottom cover.
Step 7
Lower the front of the top cover and making sure the two covers lined up
properly. Tighten the small retaining screw on the front of the bottom cover to
close the enclosure.
Bottom Cover
Universal eSATAp Cable
Universal eSATAp Cable
eSATAp to USB 3.0 Adapter
(REDESPU3 Only)
Step 6
Put the top cover on by holding it in
near vertical position and sliding the
two metal clips inside the two small
slots on the rear of the bottom cover.
Hybrid eSATA Port
(eSATAp)
USB 3.0/2.0 Port
Connecting the Ruby Enclosure to Your Computer
or