Adsl nation xte-2005 User manual

Linebox
Please read all the
instructions before
you begin.
The XTE-2005 is
designed to replace
the removable
bottom section on
the standard NTE-5
master socket as shown in the illustration
above. If your socket does not have a split de-
sign with a removable section then the socket
is either not the master socket or is part of an
old installation where the XTE-2005 will not t.
Removal of the front cover
To start, loosen the two screws on the front
of the master socket and carefully remove the
cover. If you already have extensions the wiring
will be attached to the back of the faceplate.
Make a note of the colours of the wires and the
terminal number they are connected to.
Carefully cut the securing cable tie to free the
cable and carefully
remove the wires from
the faceplate. If they
will not come free cut
the wire as close to the
connector as possible.
2 __________
3 __________
4 __________
5 __________
Making the connections
The XTE-2005 has 6 IDC terminals marked
B,A,5,4,3,2. Use an IDC tool to insert (punch)
extension wires into the terminals. To connect
your existing voice extensions connect the
wires to the numbered terminals in the same
order as removed from the original faceplate.
The extensions connected to the numbered
terminals can be used for voice only as the
ADSL signal has been ltered out.
If you would like to extend the unlterd
ADSL signal use the terminals labelled B & A.
Standard wiring colours and number to letter
conversion information is shown in the chart
overleaf.

ADSL PHONE
XTE-2005
Filtered Master Faceplate
Fits standard UK NTE5 master socket
Extension Wires
Number Letter Colour
2 B Blue/White
3 - Orange/White
4 - White/Orange
5 A White/Blue
The table above shows the standard colour
scheme. If your wire does not have the same
the same colour scheme don’t worry simply
make sure that the same numbers are con-
nected to each other for example 2-2.
Completing Installation
Use the supplied cable tie to secure the cable
to the back of the faceplate.
Look closely at the screws that were removed
from the original faceplate to determine if
they are coarse self tapping of ne machine
screws. Select the same type of screw from
the two types supplied with the XTE-2005 and
screw the XTE-2005 to the back box.
For further information and advice installing
the XTE-2005 and telephone extensions please
visit our web site.
www.adslnation.com