SeaView SVS-603 User manual

2091 Exchange Court
Fairborn, Ohio 45324
937-426-2703
www.NexSens.com
SeaView SVS-603 Wave Sensor
Quick Start Guide
1
The Seaview SVS-603 wave sensor is a highly accurate MEMS-based sensor that
reports heading, wave height, wave period and wave direction via RS-232. A
custom housing allows for easy attachment to a NexSens X2-CB data logger.
SVS-603 Buoy Mounting
Locate the sensor mount at
the center of the X2-CB data
logger plate.
Align the SVS-603 screw holes
with those of the mounting
base and gently press down.
Install the hex screws into the
holes using the included 3/16”
driver to secure the S500 to
the buoy plate.

2091 Exchange Court
Fairborn, Ohio 45324
937-426-2703
www.NexSens.com
SeaView SVS-603 Wave Sensor
Quick Start Guide
2
Data Logger Connection
1. Setup your data logger on WQData LIVE by:
a. Following the Quick Start Guide included with your order.
b. Visiting NexSens Knowledge Base | Data Logger | User Guides
on the NexSens website.
2. Once this is completed:
a. Plug the sensor into the data logger.
b. After the next logger reading, confirm that the sensor is uploaded to
the WQData LIVE project, and is showing valid readings.
c. Gather a few readings before deployment.
LED Indicator Light
A single red LED indicator is visible through the top of the wave sensor housing.
This illuminates once power is applied and blinks rapidly at the same rate of the
data message output.