ADURO Hybrid Installation guide

FAQ Cleaning the Hybrid stove
Daily Cleaning
•Clean the glass so the stove looks presentable.
•Remove the ash under the burning cave (For every 15 kg of pellets burned, which is equal to
approximately 8 hours in operation on heat level 3):
oPlace the cave to the side (use pliers) see picture 1 and use gloves if necessary for extra
protection.
oScrape the ash under the cave away into the grate (see picture 2).
oPut the burning cave back in its place.
The cleaning takes less than 3 minutes to complete. However, if the lid is open for more than 3 minutes, the
stove will automatically turn off out of safety reasons. We do not recommend that you turn off the stove when
conducting this fast cleaning, otherwise the igniter will be quickly worn down. It may be necessary to do this
cleaning every 7 to 8 hours of operation if the stove is running at heat level 3.
See this video for guidance: https://www.youtube.com/watch?v=MbCXLdixreM (watch from 08:05).
Weekly cleaning
•Vacuum clean inside of the stove, inside the small auger under the cave (once every 3-4 day).
•Remove ashpan and clean the room of the ashpan.
•Dry dust of the stove so it keeps its new look.
Additional cleaning if needed
This cleaning is necessary if you find that the combustion is getting worse. This may be due to dust and
ashes reducing the air flow in the stove.
•Remove ashes and cinders from the burning cave and combustion chamber.
•Empty the ashpan.
•Vacuum clean the inside of the combustion chamber and in the burning cave to clean the upper part
of the auger.
•Pellet stoves form dust in the stove and air pathways. The amount depends on the pellet type. Much
of this dust is burned when the stove is used in wood mode, because the temperature is higher.

Depending on the use, it will be necessary to clean the stove at the top of the combustion chamber.
Carefully remove the fireproof tile in vermiculite on the left, the baffle plate in vermiculite, and the
baffle plate in steel. Vacuum clean the upper part of the stove. Remove the bottom fireproof tile in
vermiculite, remove the plate in the back (see picture 7 below) and vacuum clean the combustion air
chamber. Replace the tiles in reverse order. Make sure that all air holes are open.
Picture 2
Picture 3
Picture 1
Picture 4
Picture 5
Picture 6

•Check fan and if necessary, brush/clean the propeller.
•Clean the burning cave and the grate for cinders, e.g. with a scraper.
•Clean the air pathway for electrical igniter from the auger. If necessary, remove the electrical igniter
and check for ashes in the white cylinder. If yes, this should be cleaned.
Yearly service maintenance
•We recommend a service visit where the stove can be checked that everything is working. This can
be done by contacting us at [e-mail]
•Spray Senotherm on the outside of the stove to maintain the fresh look i.e. those places that have
small scratches.
Picture 7
Picture 8
Picture 9