ADURO Hybrid User manual

How to replace the Hybrid stove’s control board
1. Before you start replacing the control board, it is important to check if the cables are inserted correctly (not
loose). Check if input L1-L4 are glowing when you choose manual mode in the H1 app (turning on
gearmotor, igniter, fan). If you confirm that the control board is not reacting to any commands, please follow
these steps:
a) Disconnect the stove from all electricity by unplugging the power plug.
b) Locate the control board. The entrance for the control board can be found in the stove’s bottom left corner.
See pictures below. Unscrew the two screws and pull the control board slowly out.
2. Once you have taken the control board out:
a) Take a picture of the whole control board for you to remember how it looks and how the different inputs
are connected. Start unplugging the display cable on the control board. See step 4 for illustrations regarding
how the connections should look like.
b) Unplug the rest “Green bricks”, which are input for the different electronical parts of the stove (sensors,
gearmotor, igniter etc. This is done by pulling the brick up without removing the cables itself. See pictures
below.

3. Once the green inputs are unplugged:
a) Unscrew the 4 screws that are sitting in each corner of the board.
b) Remove the control board and replace it with the new one. Screw the 4 screws in each corner:
c) Plug in the ”Green input bricks” in their rightful places. See your own picture or see step 4 below.
c) Insert the display cable.
d) Insert the power plug and wait a few seconds for the stove to restart itself. Check if the display keyboard is
reacting (the display will be lighting with a yellow light in “OFF” –see picture below). Your Aduro Hybrid is
now ready.

4: See below, how the components of the control board must be placed: