ADV TRIBE K390A1HR User manual

INSTALLATION
MANUAL
HANDLEBAR RAISERS

DISASSEMBLY OF HANDLEBAR UNIT
In order to Fit the ADV Tribe Raiser kit , Detach the Handlebar
clamp cap (2) by un bolting the top cap bolt(1) using Allen Key.
Once handlebar is detached, remove the Handlebar clamp bottom
(4) by undoing the Allen bolt (3) using appropriate Allen key.
NOTE: The Stock M6 Allen bolt will be needed for final fitting,
however M10 Allen bolt (3) will be replaced with longer Allen bolt
provided with the raiser kit.
STEP 1: 1
2
3
4
5

RAISER KIT ASSEMBLY
Now bolt the raiser spacer (3) using the M10 bolt (1) provided with the
kit in configuration as shown in figure.
(Note: Do check the orientation of the raiser spacer; same can be
identified by matching the grooving pattern step on the spacer)
Once the bottom clamp and raiser kit is attached, mount the
handlebar and secure it.
(Note: Adjust the handle bar orientation so as there is no tension
on any of the cables and wires running from switch units, clutch
STEP 2:
2
4
3
1