Advantech 98910770500 Installation and operation manual

98910770500 Startup Manual 1
Before you begin installing your card, please make sure that
the following items have been shipped:
1. 98910770500 Flex I/O
2. 4 x M3 screw P/N: 1930005673-11
3. 1x 4x GbE PoE FIO cover PN: 1960094142N001
If any of these items are missing or damaged, please con-
tact your distributor or sales representative immediately.
Note:  AcrobatReaderisrequiredtoviewanyPDFle.
Acrobat Reader can be downloaded at: get.
adobe.com/reader (Acrobat is a trademark of
Adobe)
The driver of 98910770500 is provided on 98910770500
product page. Please download it and install.
98910770500 4x GbE PoE Advanced Flex I/O
Startup Manual
General
98910770500: 4x GbE PoE Flex I/O
• Support 4x GbE PoE
• Chipset: 1x Intel i350 Ethernet controller
• Interface : B/B connector, 1x PCIe x4 for Intel i350
• LAN speed: 10/100/1000 Mbps
• PoE Output Power: Max. 10W per port (Total Max. 40W),
802.3.af PoE Compliant
• SupportPoEon/o󰀨control
• PoE LED Status Indicators:
- PoE power on, status normal: LED On
- PoE power status abnormal (port over load, port short
circuit, port failed at startup): LED 0.8Hz Blink
-PoEpowero󰀨:LEDO󰀨
Supports Model: MIC-770
* Q SKU only.
• Operating Temperature: -10 ~ 40° C with 0.7 m/sec air ow:
with Industrial SSD
• Storage Temperature: - 40 ~ 85° C (-40 ~185° F)
• Relative Humidity: 95% @ 40° C (non-condensing)
Mechanical and Environmental
• Dimensions (L x W): 169 x 156 mm
• Net Weight: 0.09 Kg
P/N Connector Function
98910770500 RJ45 CH1~4
This device complies with the requirements in Part 15 of
the FCC rules. Operation is subject to the following two
conditons:
1. This device may not cause harmful interference;
2. This device must accept any interference received,
including interference that may cause undesired opera-
tion.
Packing List
For more information on this and other Advantech
products, please visit our website at:
http://www.advantech.com
For technical support and service, please visit our
support website at:
http://advt.ch/MIC7FIO000
This manual is for the 98910770500 Series Rev. A1.
Part No. 2041077020
Printed in China
1st Edition,
July 2020
Specications
Connectors
Software Installation
Declaration of Conformity

2 98910770500 Startup Manual
Board Layout
Figure 1: Board Connectors Locations
Note: 4x GbE PoE only occupy one system I/O port.
4x GbE PoE Flex I/O Installation
98910770500 is supported by MIC-770*.
*Q SKU only..
Preparation:
Disassemble the bottom cover and 2x front FIO covers from MIC-770.
Disassemble HDD tray from MIC-770.
Assemble Advanced Flex I/O:
1. Assemble the PoE FIO cover.
2. Align 96910770500 B/B connector (male) to the B/B connector (female) on MIC-770 main board. Then assemble
96910770500 with 3x M3 screws.
Figure 3: PoE FIO Installation
Intel i350
PoE
2
1
Assembly Process