AE QUALIFIER SERIES User manual

2/13

20
:: Trouble Shooting
Solution
Charge battery.
Plug in battery.
Reset speed control using
your instruction manual.
Re-bind transmitter to the receiver.
Plug in motor.
Reset speed control using your
instruction manual.
Replace motor.
Plug servo in.
Free up steering linkage.
Replace servo.
Check throttle reversing switches
on transmitter. Reverse motor
wires. Reset speed control.
See ESC Manua.
Check steering reversing switches
on transmitter.
Check for loose wires or check for
or dead radio batteries.
Radio interference.
Check that reverse mode has not
been turned off. Refer to speed
control instructions. Reset speed
control, or send in for repair.
Let speed control cool off. Check
gear, gear mesh, or bind in driveline.
Let motor cool and check
recommended gearing for motor
type.
Reset gear mesh (see instruction
manual).
Description
No Power
No Throttle
No Steering
Throttle
Steering
Vehicle is
glitching
Reverse
Vehicle dies
or slows
Problem
Battery is discharged...........
Battery not plugged in.........
No light on speed control....
Receiver LED remains red.
Motor not plugged in............
Speed control out of ............
adjustment.
Motor failure............................
Servo not plugged in.............
Locked up steering linkage.
Servo failure.............................
Goes backwards when you
pull the trigger, or forward
when pushing brakes /
reverse.
Goes right when turning......
the wheel left (or left when
turned right.)
Vehicle has a problem on.....
power.
No reverse or brakes...........
Speed control overheats....
Motor overheats...................
Gear mesh set too tight......