AEG Perfekt Glide-24-1 User manual

Thank you for the purchase of this product. Please read the
manual carefully before op g the appliance.
Cod:0103088729-00.01Version Number：V20191127
V1.1
Perfekt Glide-24-1
Perfekt Glide-30-1
Perfekt Glide-36-1
Built-in Range Hood Instru Manual
i nperfekt

1 | P a g e
Contents
5-2snoituacerPytefaS
5seirosseccA
6serutaeF
6noitaraperPnoitallatsnI
g Ven Dire on 7
Cabinet Prep on for Hood Support 10-14
Prepar on for Duct Conne on 14
51noitallatsnIdooH
61slortnoC
61snoitacificepS
71eraCdnaesU
91-81gnitoohSelbuorT
8-9margaiDnoitallatsnI
02noitamrofnIytnarraW

2 | P a g e
Safety Prec ons
READ AND SAVE THESE INSTRUCTIONS
WARNING - to reduce the risk of fire, electrical shock, or injury,
Please read the following:
oRead all instruc s before using the appliance
oUse of this appliance is only for its intended purpose as described
in this manual
oDo not use any accessories that are not recommended by the
manufacturer
oThis unit must be grounded
oDo not use this appliance for commercial use
oDo not use with any solid-state speed control device
oIn work and electrical wiring must be done by
oWhen replacing an exis ge hood with your new AEG
Perfekt Glide range hood, turn OFF the electrical power to the
exis ng unit before removal
oUnplug the unit before cleaning or servicing
o
Note:If for any reason this product requires service,
please contact Euro-Parts 1-800-678-8352
ong or drilling into the wall or ceiling, be careful not to
damage exis ectrical wiring and any other hidden s
any parts

3 | P a g e
WARNING to reduce risk of cooktop grease fire:
element
dish cloths
off
temperatures
temperatures
the
high flame foods
can

4 | P a g e
CAUTION!
Important observe all governing codes and ordinances.
o
o
to exhaust hazardous or explosive materials and vapors
To reduce the risk of fire, use only metal duct work
To avoid damage to the motor o
of
r other components, keep
To reduce risk of fire and exhaust air, be sure to duct air
outside. Do not vent the exhausted air into space within
wthe theall or
o
o
o
CAUTION!
Grounding Instruc ons
oThis appliance must be grounded. In the event of an electrical
short circuit, grounding reduces the risk of an electrical shock
by providing an escape wire for the electrical current.
This appliance is equipped with a cord that has a grounding
wire with a grounding plug. The plug must be plugged into an
outlet that is properly installed and grounded.
Improper grounding can result in risk of electric shock.
are not properly understood, or if doubt exists as to whether
the appliance is properly grounded. Do not use an extension
cord. If the power supply cord is too short, have a qualified
electrician install an outlet near the appliance
Do not operate any fan with a damaged cord or plug. Discard the
fan or return to an authorized service facility for exam n
and/or repair
o
o
Do not run a cord under carp ng. Do not cover cthe
the
the
ord with
throw rugs, runners, or similar coverings. Do not route cord
under furniture or appliances. Arrange cord away from the
arcarpet ea and where it will not be tripped over.
o

5|P a g e
Range hood accessories provided:
o1 x Range hood
o
o4 x 6mm Washers
M5x40mm
o2 x Filters
o1 x User manual
o
o
5 x Safety Torx 4x8mm screws
CAUTION!
o
o
o
o
Accessories
Do not flambé under the range hood;
CAUTION: Accessible parts may become hot when used with
cooking appliances.
The air must not be discharged into a flue that is used for
(not applicable to appliances that only discharge the air back
into the room);
CAUTION!
o
o
or other fu
should
e
in use
ls (no
in
t applicable to appliances that only discharge
the air back into the room);
There is a risk of fire if the cleaning is not carried out
oThis appliance is not intended for use by persons
or lack of experience and knowledge, unless they have been
Check to make sure that all parts and accessories are present and
or are missing parts, please contact Euro-Parts for assistance
1-800-678-8352
and
by a person responsible for their safety. Pleasesupervise
children. They should notplay with the appliance.

6|P a g e
Features
oDrill
o1/8” drill bit for pilot holes
o1-1/4” wood bit or drilling electrical wiring access hole
oPhillips head screwdriver
oFlat-head screwdriver
oPliers
oPencil, ruler and level for marking range hood lo on
oHand saw or jig saw for cu ng the wall or cabinet openings
o
oElectrica
Duct tape
l tape
oConnector clamp
oThis appliance is manufactured from top quality
materials, and o s superb streamlined e ects
oWith high on power and low noise, it is designed to remove
cooking fumes from your kitchen quietly and c vely
Installa on
Note: this procedure will require 2 people for easier in on
General Prepara on
oRemove range hood from packaging and lay upside down on
table covered with cardboard or paper to prevent
scratching of the hood or table
oBe sure the power switch is set to OFF

6

8|P a g e
Perfekt Glide-24-1
Perfekt Glide-30-1
Perfekt Glide-36-1
6
(150mm)
”
6
(150mm)
”
6
(150mm)
”
11 (280mm)
”
11 (280mm)
”
11 (280mm)
”
30”
23
2
1
”
35
2
1
”
31
8
5
”
19 (503mm)
(663mm)
(758mm)
(803mm)
(898mm)
(598mm)
16
13
”
26
32
3
”
8)mm802(
61
3”
8)mm802(
61
3”
8)mm802(
61
3”
)mm
661(
6
2
1”
)mm
661(
6
2
1”
)mm
661(
6
2
1”
17 4
3(450mm)
”
17 4
3(450mm)
”
17 4
3(450mm)
”
1
4
3)mm24(
”1
4
3)mm24(
”
1
4
3)mm24(
”

9|P a g e
Perfekt Glide-24-1
Perfekt Glide-30-1
Perfekt Glide-36-1
(60cm)238
5”
(190mm)7 2
1”
16(8mm)
5”
(640mm)2516
3”
(220mm)832
21
”
(286mm)114
1”
(320mm)1232
19
”
(30mm)
16
1”
(606mm)23 8
7”
(443mm)17 2
1”
(205mm)8”
(78.5mm)3”
(190mm)7 2
1”
(69.5mm)24
3”
(800mm)31 2
1”
(285mm)11 4
1”
(766mm)3032
5”
(603mm)23 4
3”(78.5mm)3”
(76cm)30”
(69.5mm)2 4
3”
(190mm)7 2
1”
(190mm)7 2
1”
16(8mm)
5
”
(220mm)832
21
”
(286mm)114
1”
(320mm)1232
19”
(30mm)
16
1”
(940mm)
37”
(906mm)3532
21
”
(743mm)29 4
1”
16(8mm)
5”
(190mm)7 2
1”
(190mm)7 2
1”
(90cm)3516
7”
(69.5mm)24
3”
(355mm)14”
(220mm)832
21
”
(286mm)114
1”
(320mm)1232
19”
(30mm)
16
1”

Cabinet Prepara on for Hood Support
If you install the hood with a duct,
you will need to provide a hole for
the duct. Please use the template
provided to locate the hole.
10 |P a g e
The range hood should be mounted at a minimum
a minimum
distance
of 24 ”from an electric or indu on cooktop, and
distance of 30” above a gas cooktop for safety and opmum
performance.
84(210mm)
1”
(443mm)
17 2
1”(603mm)
23 4
3”
280mm)
11”
(743mm)
29 4
1”
6 (150mm)Diameter
”
(70mm)
24
3”
(503mm)
1916
13”(663mm)
2632
3”(803mm)
31 8
5”
(30mm)
116
3”
88
5
5
”
(220mm)
4 x Ø6mm 72
1”
(190mm)
72
1”
(190mm)

fThen asten the wood strips with wood screws about 3”
fin rom each end.
NOTE:
slightly more than the recessed dimension. The
2. Measure and mark the electrical wiring opening in
also mark and measure the duct opening in the wall
or cabinet.
11 |P a g e
Before installing the range hood, first fix the duct outlet on the air
duct hole of the hood.

12 |P a g e
RECOMMENDED CABINET MINIMUM CLEARANCE
ons are subject to change without no
V1.3
24”-30”
(600mm-762mm)
24”
609mm
Perfekt Glide-24-1

13 |P a g e
RECOMMENDED CABINET MINIMUM CLEARANCE
V1.3
24”-30”
(600mm-762mm)
Perfekt Glide-30-1

14 |P a g e
RECOMMENDED CABINET MINIMUM CLEARANCE
V1.3
24”-30”
(600mm-762mm)
Perfekt Glide-36-1

15 |P a g e
Hood Installa on
Connect the ductwork on the
hood, using duct tape to make
Power cord
WARNING: TO REDUCE THE RISK OF FIRE, USE ONLY METAL
DUCTWORK AND DUCT CONNECTION DEVICE.
Your new range hood will operate at the highest
the number of elbows and the length of the duct are kept to
a
ifefficiency

16 |P a g e
Perfekt Glide-36-1
122W
120W
6”
2 x 1W
122W
110-120V~
110-120V~
110-120V~
120W
6”
2 x 1W
122W
120W
6”
2 x 1W
Perfekt Glide-24-1
Perfekt Glide-30-1
When , the hood will turn on.
of the hood.
.2

17 |P a g e
For highest efficiency, the filter should be removed and
cleaned once a month. Soak the filter in hot water with a mild
soap or detergent. Rinse thoroughly and repeat if necessary.
The filter is also dishwasher safe. Heavy grease buildup may not
be cleaned easily, therefore the filter may need to be
replaced in certain cases.
Light Bulb
This model requires 2 x 1W LED light bulbs.
Exterior surface
Do NOT use abrasive materials such as steel wool pads or
scouring pads.
detergent suitable for painted surfaces.
Repairs or Replacement Parts
Warning! Disconnect the range hood from the electrical power
supply before servicing.
All parts may be obtained from Euro-Parts 1-800-678-8352.
When ordering parts, please specify the range hood model
number located onthe ng label, which can be found
on the inside of the range hood.

18 |P a g e
Trouble Sh g
If any problems occur, please detach the plug from the
electrical outlet and contact Euro-Parts or an authorized
servicer in order to avoid an accident.
Fan does not turn on (but light turn on).
This is probab
Please contact Euro-Parts or an authorized servicer to fix this
problems.
ly due to either a def ve fan switch or a
burned out fan motor. Both can be replaced without
removing the range hood from the wall or cabinet. Use an
ohm meter to determine which component is not working. If
the ohm meter reads that the fan switch has 0 ohms of
resistance, then it is the motor that needs to be replaced. If it
reads anything other than zero, then the switch must be
replaced.
Fan runs at two speed.

19 |P a g e
L1 L2-Lamp M-Motor K1-Mains Power Switch
K2-Motor Switch K3-Lamp Switch
110-120V~60Hz
12uF/250V
L2
L1
K1
K2
K3
Light does not turn on (but fan turns on).
This could be because the bulb has burned out. Try replacing
the light bulb. If the light s ll does not work, either the light
switch or the lamp-holder socket could be defec ve. Both can
be replaced without having to remove the range from the wall
or cabinet.