AEG Perfekt Glide-24 User manual

Perfekt Glide-24
Perfekt Glide-30
Perfekt Glide-36
Built-in Range Hood Instruc Manual
Thank you for the purchase of this product. Please read the
manual carefully before op g the appliance.
iŶĨŽƌŵƵŶĚĨƵŶŬƟŽnperfekt
Cod:0103079673

1|P a g e
Contents
Safety Precau ons 2-5
5seirosseccA
5serutaeF
6
7
8-9
9
10
11
12snoitacificepS
Use and Care
Trouble Shoo g
In Diagram
Warranty Informa on
Minimum Height Safety Requirements
13
14-15
16
17

2|Page
Safety Precautions
READ AND SAVE THESE INSTRUCTIONS
WARNING ʹto reduce risk of fire, electrical shock, or injury,
observe the following:
oRead all instructions before using the appliance
oUse this appliance only for its intended purpose as
described in this user manual
oDo not use any accessories not recommended by the
manufacturer
oThis unit must be grounded
oDo not use this appliance for commercial use
oDo not use with any solid-state speed control device
oInstallation work and electrical wiring must be done by
qualified technicians in accordance with all applicable
codes and standards, including fire-rates construction
oSufficient air is needed for proper exhausting of gases of
fuel burning equipment through the chimney to prevent
back drafting. Follow the cooktop manufacturer's
ŐƵŝĚĞůŝŶĞĂŶĚƐĂĨĞƚLJƐƚĂŶĚĂƌĚƐ
o:hen replacing an existing range hood with your new
AEG Perfekt Glide range hood, turn OFF the electrical
power to the existing unit before removal
o8nplug the unit before cleaning or servicing
o'o not repair or replace any part of the appliance or
attempt servicing. Note: if for any reason this product
requires service, please contact Euro-Parts 1-800-678-
8352
o:hen cutting or drilling into wall or ceiling, be careful
not to damage existing electrical wiring and other hidden
utilities
o'ucted fans must always be vented to the outdoors

3|Page
WARNING ʹto reduce risk of cooktop grease fire:
oNever leave cooking unattended at high settings. Boil-
overs cause smoking and greasy spillovers may ignite.
Heat oils slowly on low or medium settings
oAlways turn the hood on when cooking at high heat or
when cooking flaming food (i.e. Crepes Suzette, Cherries
Jubilee, Flambés)
oClean ventilation fans frequently. Do not allow grease to
accumulate on the fan or filter
oUse proper sized pans that correspond to the size of the
stove and the amount of food being cooked
WARNING ʹto reduce risk of personal injury in the event of
a cooktop grease fire:
oSmother flames with a close-fitting lid, metal tray, or
baking sheet. Then turn the burner OFF. BE CAREFUL TO
AVOID BURNS. If the flames are not extinguished
immediately, evacuate and call the fire department.
oNEVER pick-up a flaming pan
oDO NOT use water, including wet dishcloths or towels
to put out a fire. A violent steam explosion may result
oUse a fire extinguisher only if:
a. You know that you have a Class ABC extinguisher and
know how to use it
b. The fire is small and contained in the area it started
c. The fire department is being called
d. You can use the extinguisher with your back to an exit

4|Page
CAUTION!
Important ʹobserve all governing codes and ordinances.
oFor general ventilation use only. Do not use this
appliance to exhaust hazardous or explosive materials
and vapors
oTo reduce the risk of fire, use only metal duct work
oTo avoid damage to motor or other components, keep
drywall spray, construction dust, etc. off the power unit
oPlease read the specification label on product for further
information and requirements
oTo reduce risk of fire and exhaust air, be sure to duct air
outside. Do not vent exhaust air into the space within
the walls or ceiling, or into attic, crawl space or garage
CAUTION!
Grounding Instructions
oThis appliance must be grounded. In the event of an
electrical short circuit, grounding reduces the risk of
electrical shock by providing an escape wire for the
electrical current. This appliance is equipped with a cord
having a grounding wire with a grounding plug. The plug
must be plugged into an outlet that is properly installed
and grounded.
oImproper grounding can result in a risk of electric shock.
Consult a qualified electrician if the grounding
instructions are not properly understood, or if doubt
exists as to whether the appliance is properly grounded.
Do not use an extension cord. If the power supply cord is
too short, have a qualified electrician install an outlet
near the appliance

5|P a g e
CAUTION!
oDo not operate any fan with a damaged cord or plug.
Discard fan or return to an authorized service facility for
examin on and/or repair
oDo not run cord under carpe ng. Do not cover cord with
throw rugs, runners, or similar coverings. Do not route
cord under furniture or appliances. Arrange cord away
from t c area and where it will not be tripped over.
Accessories
Range hood accessories provided:
o1 x Range hood
o
o4 x 6 Washers
o2 x Filters
o1 x User manual
o8 x ST4x8 screws
o
o Restrictor Plate
Check to make sure that all parts and accessories are present
and in good cond on. If you nd tha hey are not in working
cond on or missing, please contact Euro-Parts for assistance
1-800-678-8352
Features
This appliance is manufactured from top quality
materials, and o s superb streamlined e ects
With high on power and low noise, i s designed to remove
cooking fumes from your kitchen quietly and c vely

6|P a g e
Installa on
Pic 1
Minimum Safety Height Requirement
1. The range hood should be mounted
at a distance of 600mm from an
electric or in cooktop, and
762mm above a gas cooktop for
safety and m performance. If
the instruc ons for installa of the
gas cooktop specify a greater
distance, this has to be taken into
account. (see pic 1) The exhaust air must
not be discharged into a chimney which is used for
exhaus ng fumes from other appliances burning gas or
other fuels.
600
–
762mm
For the province of B h Columbia
The base of the AEG insert hood is made of stainless steel and uses a
stainless steel filter. There are no components on the lower
side of the hood. In the housing of the motor is metal.
These hoods are tested at 24” above gas cooktops in the produc n
test facility. At this height, igni on is not possible. The hoods can be
installed 24” above gas cooktops.

Note: this procedure will require 2 people for easier in on
General Preparaon
Remove rangehood from packaging and lay upside down on
table covered with cardboard or paper to prevent
scratching ohe hood or table
Be sure the power switch is seo OFF
Drill
1/8” drill bit for pilot holes
1-1/4” wood bior drilling electrical wiri ng access hole
Phillips head screwdriver
Flat-head screwdriver
Pliers
Pencil, ruler and level for marking range hood lo on
Hand saw or jig saw for cu ng the wall or cabinetopenings
Ducape
Electrical tape
Connector clamp
Installaon Preperaon

8
”
25
4
”
15
3
6
/7cm
/4cm

9|P a g e
Cabinet Prepara on for Hood Support
The range hood should be mounted at a distance of 24”
from an electric or indu on cooktop, and 30”above a
gas cooktop for safety and op mum performance.
If you install the hood with a duct,
you will need to provide a hole for
the duct. Please use the template
provided to locate the hole.
15”
4-ST4*35
72
1”45
3”
75
3”
210
3”
15
2”

10|P a g e
Fasten the wood strips with wood screws about 3” in
from each end.
NOTE:
slightly more than the recessed dimension. The
2. Measure and mark the electrical wiring opening in
also mark and measure the duct opening in the wall
or cabinet.
Prepara on for Duct Connec on
When you choose to operate the Rangehood in
“Recirculation”mode, ensure that the restrictor plate is
installed over the duct opening.
Restrictor Plate
When you choose to operate the Rangehood in
“Vented” mode, ensure that the duct outlet is installed
before mounting the rangehood.
Duct Outlet

11 |P a g e
Hood Installa on
L the hood to the
proper po on in the
cabinet x the self-
tapping screw with
washers. Follow the
middle four holes on the
top shelf inside ohe
hood.
Do not damage the parts insidethe hood.
Connect theductwork on the
hood,usingduct tapeto make
Power cord (length 0.9 -1.2m)
Your new range hood willoperate ahe highest iency if
the number of elbows and the length ohe duct are kepo
a minimum.
WARNING：TO REDUCE THE RISKOF FIRE, USE ONLY METAL
DUCTWORK AND DUCT CONNECTIONDEVICE FOR THE APPLIANCE
WITH LOGO cETLus OR ETLus ,FOR THE APPLIANCE WITH LOGO
cETL,THE DUCTWORK AND DUCT CONNECTIONDEVICE MAY BE
NON-METALLIC.

72W
70W
260 CFM
6”
2 x 1W
72W
115
115
70W
260 CFM
6”
2 x 1W
72W
Perfekt Glide-36
115
70W
260 CFM
6”
2 x 1W
12

13 |P a g e
Use and Care
Filter
For highest efficiency, this filter should be removed and
cleaned periodically. Soak the filter in hot water and mild
soap or detergent. Rinse thoroughly and repeat if necessary.
The filter may be cleaned inthe dishwasher. Heavy grease
buildup may not be cleaned easily, thus the filter may need
to be replaced.
Charcoal Filter
Inspect this filter periodically. This filter cannot be cleaned
and must be replaced.
Light Bulb
This model specifies 2 x 1W LED light bulbs.
Exterior surface
Wipe the range hood exterior with a so cloth and a mild
detergent suitable for painted surfaces. Do NOT use abrasive
materials such as steel wool pads or scouring pads.
Repair or Replacement Parts
Warning! Disconnect range hood from the electrical power
supply before servicing.
All parts may be obtained from Euro-Parts 1-800-678-8352.
When ordering parts, please specify the range hood model
number on the rang label, which is located onthe inside of
the range hood.

14 |P a g e
Trouble Shooting
If any problem occurs, please detach the plug from the socket
and contact Euro-Parts or a similarly qualified person in order
to avoid a hazard.
Fan does not turn on (but light turns on).
This is probably due to either a defecve fan switch or a
burned out fan motor. Both can be replaced without
removing the range hood from the wall or cabinet. Use an
ohm meter to determine which component is not working. If
the ohm meter reads that the fan switch has 0 ohms of
resistance, then it is the motor that needs to be replaced. If it
reads anything other than zero, then the switch must be
replaced.
Fan only runs at one speed.
Please see above instrucons.
Fan circulates air, but does not vent outside.
If air is blowing through the front vent openings, then your
range has been installed for ductless operaon. In order to
convert the system to vent outside, a technician must install
ductwork from the range hood through either an outside wall
or the roof.
If air is not blowing from the front vent openings, check inside
the cabinet around the range hood. If you see a duct leading
away from the vent hood, then you have a system that vents
to the outdoors. If you do not see a duct, your unit may be
venng through the back wall.

15 |P a g e
Light does not turn on (but fan turns on).
This could be because the bulb has burned out. Try replacing
the light bulb. If the light sll does not work, either the light
switch or the lamp-holder socket is defecve. Both can be
replaced without removing the range from the wall or
cabinet.
Range hood does not turn on at all.
Check for a tripped circuit breaker or a blown fuse, since the
range hood is wired directly to your household electrical
system.
NOTE: All work must be performed by a qualified licensed
technician.

16 |P a g e
Installa on Diagram
Perfekt Glide-24
Perfekt Glide-30
18”
18”
11”
11”
6”
6”
28”
30”
23
2
1
”
21
5
4
”
7
10
7”
5
10
9”
7
10
7”
5
10
9”
Perfekt Glide-36
18”
11”
6”
34”
36”
70
1
7
”
50
1
9
”

17 |P a g e
perfek in n
Warranty
AEG Appliances are imported and distributed in North
America by Euro-Line Appliances Inc.
For more informa on visit www.euro-line-appliances.com
or contact:
871 Cranberry Court,
Oakville, Ontario. L6L6J7
Canada
Tel [phone]
1-800-421-6332 – Euro-Line Appliances Inc.
1-800-ELA-WEST – Euro-Line Appliances West
marke [email protected]
All AEG Appliances are backed by a comprehensive 2-year
parts and labour warranty. Informa on on service and parts
is available from Euro-Parts at 1-800-678-8352