AEG Perfekt Glide-24 User manual

Perfekt Glide-24
Perfekt Glide-30
Perfekt Glide-36
Built-in Range Hood Instrucon Manual
Thank you for the purchase of this product. Please read the
manual carefully before opg the appliance.
in form und funkonperfekt
Cod:0103079673

1 | Page
Contents
Safety Precautions 2-5
Accessories 5
Features 6
Installation Preparation 6
Selecting Venting Direction 7
Cabinet Preparation for Hood Support 8-9
Preparation for Duct Connection 9
Hood Installation 10
Controls 11
Specifications 11
Use and Care 12
Trouble Shooting 13-14
Installation Diagram 15
Warranty Information 16

2 | P a g e
Safety Precauons
READ AND SAVE THESE INSTRUCTIONS
WARNING to reduce risk of fire, electrical shock, or injury,
observe the following:
oRead all instrucons before using the appliance
oUse this appliance only for its intended purpose as
described in this user manual
oDo not use anyaccessories not recommended bythe
manufacturer
oThis unit must be grounded
oDo not use this appliance for commercial use
oDo not use with anysolid-state speed control device
oInstallaon work and electrical wiring must be done by
qualified technicians in accordance with all applicable
codes and standards, including fire-rates construcon
oSufficient air is needed for proper exhausng of gases of
fuel burning equipment through the chimneytoprevent
back draing. Follow the heang equipment
oWhen replacing an exisng range hood with your new
AEG Perfekt Glide range hood, turn OFF the electrical
power tothe exisng unit before removal
oUnplug the unit before cleaning or servicing
oDo not repair or replace any part of the appliance or
aempt servicing. Note:If for any reason this product
requires service, please contact Euro-Parts 1-800-678-
8352
oWhen cung or drilling intowall or ceiling, be careful
not todamage exisng electrical wiring and other hidden
ulies
oDucted fans must always be vented tothe outdoors

3 | Page
WARNING ʹto reduce risk of cooktop grease fire:
oNever leave cooking unattended at high settings. Boil-
overs cause smoking and greasy spillovers may ignite.
Heat oils slowly on low or medium settings
oAlways turn the hood on when cooking at high heat or
when cooking flaming food (i.e. Crepes Suzette, Cherries
Jubilee, Flambés)
oClean ventilation fans frequently. Do not allow grease to
accumulate on the fan or filter
oUse proper sized pans that correspond to the size of the
stove and the amount of food being cooked
WARNING ʹto reduce risk of personal injury in the event of
a cooktop grease fire:
oSmother flames with a close-fitting lid, metal tray, or
baking sheet. Then turn the burner OFF. BE CAREFUL TO
AVOID BURNS. If the flames are not put out
immediately, evacuate and call the fire department.
oNEVER pick-up a flaming pan
oDO NOT use water, including west dishcloths or towels
to put out a fire. A violent steam explosion may result
oUse a fire extinguisher only if:
a. You know that you have a Class ABC extinguisher and
know how to use it
b. The fire is small and contained in the area it started
c. The fire department is being called
d. You can use the extinguisher with your back to an exit

4 | Page
CAUTION!
Important ʹobserve all governing codes and ordinances.
oFor general ventilation use only. Do not use this
appliance to exhaust hazardous or explosive materials
and vapors
oTo reduce the risk of fire, use only metal duct work
oTo avoid damage to motor or other components, keep
drywall spray, construction dust, etc. off the power unit
oPlease read the specification label on product for further
information and requirements
oTo reduce risk of fire and exhaust air, be sure to duct air
outside. Do not vent exhaust air into space within wall or
ceiling, or into attic, crawl space or garage
CAUTION!
Grounding Instructions
oThis appliance must be grounded. In the event of an
electrical short circuit, grounding reduces the risk of
electrical shock by providing an escape wire for the
electrical current. This appliance is equipped with a cord
having a grounding wire with a grounding plug. The plug
must be plugged into an outlet that is properly installed
and grounded.
oImproper grounding can result in a risk of electric shock.
Consult a qualified electrician if the grounding
instructions are not properly understood, or if doubt
exists as to whether the appliance is properly grounded.
Do not use an extension cord. If the power supply cord is
too short, have a qualified electrician install an outlet
near the appliance

5|P a g e
CAUTION!
oDo not operate any fan with a damaged cord or plug.
Discard fan or return to an authorized service facility for
examin on and/or repair
oDo not run cord under carpe ng. Do not cover cord with
throw rugs, runners, or similar coverings. Do not route
cord under furniture or appliances. Arrange cord away
from t c area and where it will not be tripped over.
Accessories
Range hood accessories provided:
o1 x Range hood
o
o4 x 6 Washers
o2 x Filters
o1 x User manual
o5 x ST4x8 screws
o
oAddional handle rail (Bigger handle rail is for
recirculaon mode, Smaller Handle rail is for Duct
connecon)
oPVC Cover (Maybe fied on hoods for ducng mode)
Ducng outlet
Check to make sure that all parts and accessories are present
and in good cond on. If you nd that they are not in good
cond on or missing, please contact Euro-Parts for assistance
1-800-678-8352

6|Page
Features
oThis appliance is manufactured from top quality
materials, and oīĞƌs superb streamlined eīects
oWith highƐƵĐƟon power and low noise, it is designed to remove
cooking fumes from your kitchen quietly and ĞīĞcƟvely
InstallaƟon WƌĞƉĂƌĂƟŽŶ
Note: this procedure will require 2 people for easier inƐƚĂůůĂƟon
General PreparaƟon
oRemove range from packaging and lay upside down on
table covered with cardboard or paper to prevent
scratching of the hood or table
oBe sure the power switch is set to OFF
dŽŽůƐŶĞĞĚĞĚĨŽƌŝŶƐƚĂůůĂƟŽŶ
oDrill
o1/8” drill bit for pilot holes
o1-1/4” wood bit for drilling electrical wiring access hole
oPhillips head screwdriver
oFlat-head screwdriver
oPliers
oPencil, ruler and level for marking range hood loĐĂƟon
oHand saw or jig saw for cuƫng the wall or cabinet openings
oDuct tape
oElectrical tape
oConnector clamp

6

8|P a g e
Cabinet Prepara on for Hood Support
The range hood should be mounted at a distance of 24”
from an electric or indu on cooktop, and 30”above a
gas cooktop for safety and op mum performance.
If you install the hood with a duct,
you will need to provide a hole for
the duct. Please use the template
provided to locate the hole.
15”
4-ST4*35
95
1”45
3”
85
1”
210
3”

9|P a g e
Fasten the wood strips with wood screws about 3” in
from each end.
NOTE:
slightly more than the recessed dimension. The
2. Measure and mark the electrical wiring opening in
also mark and measure the duct opening in the wall
When you choose the Ducng mode, screwdriver wind board
fixed hood, ensure the PVC cover fixed on recirculaon holes,
Keep the small handle rail installed on hood
When you choose recirculaon mode, keep the PVC cover
removed from hood get recirculaon holes out. Keep the
bigger handle rail installed on hood.
or cabinet.
Prepara on for Duct Connec on
Before installing the range hood, please rst xthe outlet on