Aeris A300 XT User manual

NORM (TECH) Surface Main
(no dive yet, Nitrox)
Press any button to activate.
Once 10 minutes elapse, while on the suface prior to a dive, operation enters
Power Saver Mode (PSM) until a button is pressed to resume operation.
Surface Sequence:
MAIN >> ALT 1 > ALT 2 > ALT 3 > FLY/DESAT > LOG > SET > HIST > ID.
• Press & release - to step, or hold
to scroll, through the Surface
Sequence.
• In Settings - increases value.
• Press & release - to step back
through the Surface Sequence.
• In Settings - decreases value.
• From Surface Sequence or in
Settings, hold (2 sec), or no
button action (2 min) - reverts to
Surface Main.
• From Surface Main, press &
release, or hold - for Backlight.
• In Surface Sequence - selects
item.
• In Settings - saves value.
• From Surface Sequence or
Settings, hold (2 sec) - to step
back to a previous item.
A
S
M
A
M
S
<< WARNING >>
You must read and understand the Operating Manual (on the enclosed
CD) and the Dive Computer Safety and Reference Manual (booklet
enclosed) before diving with this product.

© 2002 Design, 2012 Doc. No. 12-7256-r01 (4/25/12)
<< NOTE >>
Dives begin automatically upon descent to 5 FT (1.5 M) for 5 seconds.
Upon ascent to 2 FT (0.6 M) for 1 second, operation shifts to Surface Mode.
Once 10 minutes elapse after surfacing from a dive, another descent is
considered a new dive.
Once 20 minutes elapse after surfacing from a dive, operation enters Power
Saver Mode (PSM) until any button is pressed to resume operation.
NORM (TECH) Dive Main
(Nitrox)
A
S
M
• From Dive Main, press & release
- to step through Alternate
displays, then revert to Main.
• With Deep Stop ON, hold (2 sec)
- to view Preview screen.
• In Gas Switch Sequence, press
& release - to step forward
through selections.
• From Dive Main, hold (2 sec) - to
access Gas Switch Sequence.
• In Gas Switch Sequence, press
& release - to step back through
selections.
• In Gas Switch Sequence, hold (2
sec) - to revert to Dive Main.
• With Safety Stop Timer ON,
press & release - to Start/Stop
the Timer.
• From Dive Main, press &
release, or hold - for Backlight.
• In Gas Switch Sequence, press
& release - to select that Gas.
A
M
S