AeroVironment EVSE-RS User manual

POWER PRESENT
The charging dock is receiving
AC power.
READY TO CHARGE
The charging dock is ready to
charge or charging is paused.
VEHICLE CONNECTED
The connector is properly
connected to the vehicle port or
the charge is complete.
VEHICLE CHARGING
The vehicle is being charged.
TROUBLE
There is an error. Try removing
the connector and inserting
back into the vehicle. If
TROUBLE indicator is still
illuminated call Customer
Service at 888-833-2148.
START
Press to resume charging after
manual STOP. You do not need
to press START in order to
begin a regular charge. The
POWER PRESENT and READY
TO CHARGE lights must be on.
STOP
Press to manually pause
charging. You do not need to
press STOP to complete a full
charge. The device will stop
automatically when it reaches
full charge.
RELEASE BUTTON
Press to release the Connector
from the charging dock or the
vehicle port.
Home Charging Dock
Model EVSE-RS
Copyright © 2011 AeroVironment, Inc. - All rights reserved. AeroVironment and AV are trademarks of AeroVironment, Inc.
0111_10168
Prototype image shown. Production model may vary.
START
STOP
START
STOP
POWER PRESENT
READY TO CHARGE
VEHICLE CONNECTED
VEHICLE CHARGING
TROUBLE

Home Charging Dock
Model EVSE-RS
Before charging...Is the ‘POWER PRESENT’ light on?
Is the ‘READY TO CHARGE’ light on?
Is the ‘TROUBLE’ light off?
For assistance, call Customer Support at [phone].
Charge Smarter. Drive Farther.™
0111_10168
VEHICLE CONNECTED
123
TROUBLE
VEHICLE CHARGING
5
ST A RT
STO P
ST A RT
STO P
6
8
ST A RT
STO P
4
7
STT
AR
STOP
STT
AR
STOP
POWER PRESENT
READY TO CHARGE
VEHICLE CONNECTED
VEHICLE CHARGING
TROUBLE
STT
AR
STOP
STT
AR
STOP
Remove the connector from the
vehicle. Rewrap the charging cable
around the cable hanger, and insert
the Connector into the charging
dock for storage.
WARNING: Failure to rewrap
cable could result in tripping
or strangulation hazard.
You are now ready to drive!
Press the button on the
connector to release it
from the charging dock.
Charging will begin
automatically. When
charging begins, the
VEHICLE CHARGING
light will start to blink.
There is no need to
press START.
Unwrap the cable from
around the cable hanger.
Charging will stop automatically
when complete. Or, you can
manually stop charging by
pressing STOP. In either case,
when the READY TO CHARGE
light blinks, remove the
connector from the vehicle
charge port. If you manually
paused charging by pressing
STOP, you can press START
to resume charging.
Insert connector firmly into
the vehicle charge port.
When fully inserted, the
VEHICLE CONNECTED
light on the charging dock
will illuminate.
When the VEHICLE
CHARGING light stops
blinking on the charger,
press the button on the
connector to release.
Pull to remove from
vehicle charge port.
Read and follow the User’s Manual before attempting to use your Home Charging Dock. Failure to follow each instruction could result in serious injury or death. The following
instructions are intended as a quick guide for using your Home Charging Dock and are not intended to be a substitute for reading and following each instruction in the User’s Manual.
Quick Start Guide