Aerpro APMSMG1 User manual

APMSMG1
aerpro.com
DASH & VENT MOUNT
MAGNETIC HOLDER
manual

Device Compatibility
This product is designed for use with MagSafe
Compatible iPhones and cases.
On supported models, MagSafe charging
magnetic holders snap to the back of an
iPhone or its MagSafe case or sleeve.
The magnets ensure proper alignment for fast
wireless charging.
Compatible devices include iPhone 12 and
onwards.

Fixing Plate
Hook
Clip
Adjustable Collar
Adhesive
Mount
Charging
Contact
Magnetic
Head
Alignment
Magnet
Product Information

1. Place the adjustable collar over the ball of
the mount
2. Press the ball of the mount into the back of
the magnetic head
3. Move the magnetic head to the desired
position and tighten the adjustable collar.
Attaching the adhesive mount to a flat
surface
1. Clean any oil, debris, or dust on the area
where 3M base is to be placed. If possible use
an alcohol wipe to help with adhesion.
2. Peel off the protection sheet from the 3M
base and stick to chosen area by strongly
pressing the base for an extended period of
time.
3. The strength of the 3M tape will perform
perfectly after 4-5 hours of installation.
4. Do not use the magnetic holder for the above
period of time or the mount may become
unstuck.
Attaching the mount to the holder

1. Unfasten the hook clip sufficiently by
rotating the fixing plate.
2. Insert the hook clip to the center of the vents
3. Rotate the adjustable collar so that the fixing
plate tightens against the hook to avoid the
presence of any gap between fixing plate and
vent.
4. Check if vent clip is fixed firmly and
correctly.
Attaching the hook mount to a vent
The Vent Mount is designed to be used only
with FLAT air vent blades.
*
Attaching the adhesive mount to a flat
surface
1. Clean any oil, debris, or dust on the area
where 3M base is to be placed. If possible use
an alcohol wipe to help with adhesion.
2. Peel off the protection sheet from the 3M
base and stick to chosen area by strongly
pressing the base for an extended period of
time.
3. The strength of the 3M tape will perform
perfectly after 4-5 hours of installation.
4. Do not use the magnetic holder for the above
period of time or the mount may become
unstuck.

Attaching the hook mount to a vent

CAUTION
1. The magnet used in this product will have no
negative impact on the phone. In case of any
applications not working correctly, please
restart application and slightly adjust the
position of where smartphone is mounted.
2. Never mount a smartphone onto holder with
a magnetic credit card in the smartphone case.
3. Be careful not to have the magnet be in
reach of medical devices.
4. Periodically check the tightness of the hook
vent clip to prevent unexpected dropping of
phone.
5. When removing your smartphone from the
magnetic holder, twist and slide, rather than
pulling off directly. This will help protect the
vent blades from being removed or damaged
due to the extreme strength of the magnets.
6. Do not install the holder where it will obstruct
the drivers view.
7. Periodically check the strength of the 3M
base.
8. Do not operate phone and holder while
driving.

Inclusions
Magnetic head
Vent mount
Adhesive mount
Technical assistance
If you need assistance with your Aerpro
product call Aerpro Support Australia.
TEL: 03 – 8587 8898 FAX: 03 – 8587 8866
Mon-Fri 9am – 5pm AEST
This manual is considered correct at time of
writing but is subject to change. For latest
manuals and updates refer to the website.
www.aerpro.com