HAVOC OFFROAD HFB-08-007 User manual

Page 1
Center Console Vault, Bronco
Part # HFB-08-007
1. 2.
Components and Hardware:
Components and Hardware: Tools for Installation:
1. Top Panel.........................................................................................(1)
2. Side Panel - Left..............................................................................(1)
Side Panel - Right............................................................................(1)
3. Screws.............................................................................................(4)
4. Nuts .................................................................................................(5)
• Screwdriver (included)
• Wrench (included)
HAVOC OFFROAD
SERVICE/SUPPORT: M-F 8am - 6pm EST 1-855-460-6800 | EMAIL: [e-mail]
FOR WARRANTY INFORMATION VISIT: www.havocoffroad.com
 
REV_0.0 10/24/2022

Page 2
Part # HFB-08-007
Center Console Vault, Bronco
1. Empty the center console of any content.
2. Position the side panels into the center console.
Make sure the 2 side panel tabs are on the top and
pointed toward the back of the console.
3. Locate the 2 holes on the bottom of each side panel.

of the center console.
REV_0.0 10/24/2022

Page 3
Part # HFB-08-007
Center Console Vault, Bronco
4. There a 4 studs on the under side of the top panel. Align
the 4 studs of the top panel to the hole in the side panels.
5. Open the door on the top panel by rotating the combi-
nation lock. Use the provided nuts on the screw studs to
secure the top panel to the side panels.
 
steps to set the combiantion lock.
REV_0.0 10/24/2022

Page 4
Part # HFB-08-007
Center Console Vault, Bronco
7. Do not remove the lock to set the combination code.
The factory preset code is 0-0-0. Please ensure the combi-
nation is set to this code before beginning.
8. Press down the reset button with a sharp tool or paper
clip. Continue to press down until you have set your per-

9. Scroll the dials to set your combination then release the
button. If the combination is forgotten then simply repeat
these steps.
REV_0.0 10/24/2022