A-Tach Mounts 50321 User manual

A-Tach # 50321
Designed for: Acura TLX 2021 - 20__
ST-1 A-Tach
Mounts
NOTICE: A-Tach Mounts will not be responsible for
any damage to the ehicle or product due to the
installation and/or use of the product. The product has
been tested to fit securely to the listed ehicles.
Instructions are pro ided for your con enience.
You are responsible to determine if you ha e the
skill to attach the product without causing damage
to your ehicle or the product.
Read all instructions and iew the photos before
attaching this product.
For best results, hold the ehicle mount o er the place where the mount attaches to the dash BE ORE
attaching the de ice holder to the ehicle mount to ensure a proper fit with the location. Most often the
mount will appear to be a little too big or small for the intended location. The ehicle mount must be
installed BE ORE a de ice holder is screwed onto the ehicle mount.
Once screwed together the products are considered used and non-refundable.
The ehicle mount is not designed to be attached and taken off the ehicle repeatedly or on a regular basis.
Once it is attached, it should remain attached until you would like to permanently remo e it.
WARNING: AVOID extreme heat conditions. It can damage the device and the mount.
(1) Clean the area where the mount will attach. The
forward / lower edge of the mount will attach into
the seam between the two panels on the side of the
center console illustrated with the arrow in the
photo. The tab on the mount will go into an unseen
opening in the seam that is about 1.5 inches up
from the bottom of the seam.
(2) The upper right edge of the mount will attach
into the seam between the console side panels and
the hard plastic panel on the left center console
illustrated with the arrow in the photo.
See additional instructions on the back side.

(3) Press the thin wide tab on the bottom of the
mount all the way into the seam. NOTICE: The
mount will not go all the way into the seam if the
mount is not in the correct location.
(4) Use the seam tool if needed to open the top
seam a little. Using two hands, place your fingers
under the face plate of the mount and lift the thin
right edge of the mount up and into the seam.
Warranty and Returns
A-Tach Mounts Limited Warranty
A-Tach warrants the product to be free of all defects in materials and workmanship for a period of six (6) months
from the date of purchase. This warranty extends to the original buyer. Damaged products caused by anything
outside of shipping damage are not co ered by this warranty.
Within the period of this warranty, A-Tach has the option to repair or replace the item or refund the purchase price.
Any replacement parts will be done on an exchange basis. All repairs and ser ice must be done by A-Tach. Product
must be deli ered to A-Tach during the warranty time along with proof of purchase price and date. The shipping
and packaging costs will be the buyer’s responsibility. Labor costs and parts to repair will be A-Tach Mounts
responsibility.
A-Tach Mounts will not be responsible for any damage to the ehicle or product due to the installation and/or use
of the product. A-Tach is not responsible for damages caused by extreme heat conditions. Any abo e exclusion
may not apply in states that do not allow the exclusion or limitation. This warranty gi es you specific legal rights.
You also may ha e other rights which ary from state to state.
Returns
Before any product may be returned, A-Tach must gi e prior appro al. An RMA# (Return Merchandise
Authorization Number) needs to be gi en to the buyer to return a product. All returns must be within (30) days of
the in oice date and include proof of purchase. Any returned product must be undamaged and in like new
condition. Returned product must be scratch free with no additional holes or screw marks on the product.
A-Tach reser es the right to withhold any refund if the product is belie ed to be damaged. A return must include a
copy of the original order or in oice. All parts and components that were shipped with the original product must be
included with the returned product.
Contact Information:
A-Tach Mounts
Clarkston, WA 99403
[e-mail]