Ainfox OB-HTG002 User manual

We are forever grateful and appreciative of you considering
purchasing our product. After careful evaluation of our product
serie, we are excited to launch this product to the public as it is
more technically advanced with lots of exciting and useful
features. One of the great features added to the arsenal is its
mere size, which will require 3-4 people with about 4-5 hours of
installing time. Making it a beast at its finest!
Steel Gazebo
Assembl
OB-HTG002（DA007-3）
y Instruction

Steel Gazebo Assembly Instruction

W
M6*30

up
STEP 3:Connect the Ionger Crossbeams Band B1 using Crossbeam
Connector (Part P) Note: After sliding the Cro ssbeam Connector (Part P)
into a crossbeam you should start one bolt to hold the Crossbeam
Connector in place.

STEP 5-1: Attach the Corner Protectors (Part J1)
and the Rib Supports (Part J2) Just twist the top
two screws of (Part J2)
STEP 5-2: Slide 5 Netting
Hooks (Part Q) into Long Crossbeams (Parts B
and B1).With the sections laying on their side,
Slide 4 Netting Hooks (Part Q) into Short
Crossbeams (Parts C and C1). Then Attach (Part M6)
Note: There are two tracks. You can choose
either track to install Part Q
STEP 5-2
STEP 5-1

STEP 6
STEP 6: Assemble the Roof Frame by Attaching the Roof Ribs
Long (Part E) to the Roof Top Brace (Part K1).

STEP 7
STEP 8

Don't tighten all the screws, just
hold the（ Part I and Part H）,
until all of them are fixed
W
Tap lightly with
the screwdriver
STEP 9
STEP 10
Please note that
Parts M3 are
installed on Parts
D, and Parts M4
are on Parts E.
/

G5/G6
STEP 11
Step11 - 1 ：Install the Roof Plates （Part N5 and N6) on the Long Sides of the Gazebo.
Install the Roof Plates （Part O5) on the Short Sides of the Gazebo.
Tighten the screw (part U) halfwy,then install(Part G5 G6), and finally tighten the (Part U)
Step11-2:
1 2 3
4
G5
G6
5
G5