Air 802 AP-G300 User manual

Wireless LAN Device Series
WLAN Outdoor AP
AP-G300 User Manual
Version. 1.3.0.9a (2006.11.22)

TABLE OF CONTENTS
NOTICE..................................................................................................................................................3
PREFACE ...............................................................................................................................................5
CH 1. AP-G300 INSTALLATION........................................................................................................6
AP-G300..............................................................................................................................................6
Packing List ....................................................................................................................................6
Hardware Installation.....................................................................................................................7
CH 2. FIRST TIME CONFIGURATION ..........................................................................................12
BEFORE START TO CONFIGURE ...........................................................................................................12
KNOWING THE NETWORK APPLICATION .............................................................................................12
BASIC SETTINGS.................................................................................................................................32
ADVANCED SETTINGS.........................................................................................................................35
CONFIGURING WIRELESS SECURITY...................................................................................................38
CONFIGURING AS WLAN CLIENT ADAPTER.......................................................................................41
QUICK START TO CONFIGURE ..............................................................................................................41
MAC CLONE FOR SINGLE ETHERNET CLIENT ....................................................................................43T
CONFIGURING UNIVERSAL REPEATER ................................................................................................44
CH 3. CONFIGURING WDS..............................................................................................................46
WDS NETWORK TOPOLOGY................................................................................................................46
WDSAPPLICATION.............................................................................................................................48
CH 4.ADVANCED CONFIGURATIONS .........................................................................................50
CONFIGURING LAN TO WAN FIREWALL ............................................................................................50
PORT FILTERING .................................................................................................................................50
IPFILTERING ......................................................................................................................................51
MAC FILTERING.................................................................................................................................52
NAT (NETWORK ADDRESS TRANSLATION).........................................................................................53
CONFIGURING PORT FORWARDING (VIRTUALSERVER)..............................................................................54
MULTIPLE SERVERS BEHIND NATEXAMPLE:.....................................................................................54
CONFIGURING DMZ.........................................................................................................................555
CONFIGURING WAN INTERFACE.......................................................................................................566
STATIC IP..........................................................................................................................................566
DHCPCLIENT (DYNAMIC IP)...........................................................................................................577
PPPOE..............................................................................................................................................588
PPTP..................................................................................................................................................59
CONFIGURING CLONE MACADDRESS ...............................................................................................61
CONFIGURING DHCPSERVER ..........................................................................................................633
1

BANDWIDTH CONTROL.....................................................................................................................644
QOS(QUALITY OF SERVICE).............................................................................................................644
STATIC ROUTE SETUP .......................................................................................................................686
DYNAMIC ROUTE SETUP ....................................................................................................................69
VPN PASS-THROUGH........................................................................................................................700
USING CLI MENU.............................................................................................................................700
THE SYSTEM MANAGEMENT ............................................................................................................733
SNMPAGENT ..................................................................................................................................734
MISCELLANEOUS SETTINGS..............................................................................................................766
PING WATCHDOG .............................................................................................................................777
AIMING TOOL...................................................................................................................................788
CONNECTING PROFILE........................................................................................................................79
FIRMWARE UPGRADE .........................................................................................................................80
CONFIGURATION DATA BACKUP &RESTORE....................................................................................811
AUTO DISCOVERY TOOL...................................................................................................................822
APPENDIX A. BRIDGED NETWORK CONFIGURATION (WITH LINKSYS,ETC.) .......................................87
2

Notice
Warning：Changes or modifications to this unit not expressly approved by the
party responsible for compliance could void the user authority to operate the
equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions：(1) This device may not cause harmful interference,
and (2) this device must accept any interference received, including
interference that may cause undesired operation.
The user’s manual or instruction manual for an intentional or unintentional
radiator shall caution the user that changes or modifications not expressly
approved by the party responsible for compliance could void the user’s
authority to operate the equipment.
NOTE：This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits
are designed to provide reasonable protection against harmful interference in
a residential installation. This equipment generates uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more of
the following measures：
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to
which the receiver is needed.
Consult the dealer or an experienced radio/TV technician for help.
Changes or modifications not expressly approved by the party responsible for
compliance could void the user‘s authority to operate the equipment.
The antenna(s) used for this transmitter must not be co-located or operating in
conjunction with any other antenna or transmitter.
3

Shielded interface cables must be used in order to comply with emission limits.
This EUT is incompliance with SAR for general population /uncontrolled
exposure limits in ANSI/IEEE C95.1-1999 and had been tested in accordance
with the measurement methods and procedures specified in OET Bulletin 65
Supplement C.
CAUTION：
1. The antenna(s) used for this transmitter must be fixed-mounted on outdoor
permanent structures with a separation distance of at least 2 meters from
all persons and must not be co-located or operating in conjunction with any
other antenna or transmitter. Users and installers must be provided with
antenna installation instructions and transmitter operating conditions for
satisfying RF exposure compliance.
2. This Transmitter must not be co-located or operating in conjunction with any
other antenna or transmitter.
3. This equipment is only allowed to be professionally installed.
4

Preface
This guide is for the networking professional who installs and manages the AIR
802 AP-G300 product hereafter referred to as the “device”. To use this guide,
you should have experience working with the TCP/IP configuration and be
familiar with the concepts and terminology of wireless local area networks.
5

Ch 1. AP-G300 Installation
AP-G300
Packing List
Before you start to install the AP-G300, make sure the package contains the
following items：
●Wireless AP-G300 unit
●Mounting Kit
●2.5” U bolts
●Waterproof Connector
●Power over Ethernet (PoE) Injector
PoE Power Injector
6

Hardware Installation
Once you check off everything from the package, you can start to install the
AP-G300. You can mount to a pipe, a pole or to the side of a building. The
steps are showed in the following：
1. You must mount the AP-G300 into the bracket first.
2. You can use the 2.5 inches U bolt to mount on the pipe. The two U bolts
must be mounted tightly. Be aware of not over-tighten the U bolt.
3. After checking the AP-G300 is mounted well, you can connect the following
Steps Pictures
two cables: the RJ-45 network cable to Ethernet port of AP-G300 and the
RF cable to antenna port. The RJ-45 network connects steps are showing
as below:
Mounting picture
7

1. Separate the waterproof
connector into four parts.
2. Put these parts of
tor onwaterproof connec
the RJ-45 network cable.
12
3
4
4 3 2 1
3. Connect the RJ-45 network
e.
cable to Ethernet port of
IA. And then install those
parts of waterproof
connector one by on
3 2 1 A
4 3 2 1 B
C
aution
C: The diameter of network cable has to be round; otherwise the
Additional waterproof tool, such as waterproof tape, is recommended to
waterproof connector can’t fasten down it.
8

use to enhance the waterproof function. It is suggested to have a lightening
protector between antenna and antenna port. Connect the RF cable as the
figure of “AP-G300 RF Cable Connection” and connect the ground wire as
the figure of “AP-G300 Ground Wire Connection.”
. Plug the other end of the waterproof RJ-45 cable to the PoE device.4
The PoE device is guaranteed only in indoor environment.
9