AirApp PB1 User manual

© Copyright – AirApp Power Tools GmbH • Siemensstr. 9 – 11 • 40885 Ratingen
Operating Instructions
Pneumatic
Blowgun
WARNING
In order to reduce the risk of injury, the operating instructions and safety
regulations must have been read and understood!
Please read the operating instructions in full and for your own safety follow all of the instructions
contained therein.
Store the manual in a secure location.
Attention!
Remember that in accordance with the safety provisions of the Machinery Directive, a compressed air connec-
tion must not be made directly to the air inlet of the compressed air machine. Plug-in sleeves with pressed ends,
screwed into the air inlet of the device provide the greatest level of safety.

© Copyright – AirApp Power Tools GmbH • Siemensstr. 9 – 11 • 40885 Ratingen 2
Scope of delivery
Open the packaging and check the contents.
1 x compressed air device
1 x dehumidier
1 x safety regulations
1 x EC Declaration of Conformity
1 x operating instructions
1 x technical specications
Function of the blowgun
•The blowgun is a compressed air device and is used for blowing out.
•Never use the blowgun for any other purpose.
•Please observe the safety regulations!
Application of the blowgun
When working with compressed air devices, observe the safety regulations!
Essentially, the blowgun consists of the following main components:
1. Nozzle tube:
For pinpoint direction.
2. Handle with trigger
Starts the device.
Attention!
Never point a blowgun directly at a person.
Information for operation
•Connect device to the compressed air supply.
• Model PB1 is equipped with a rotating ring for starting and controlling the ow.
•Models PB2, PB5 and PB10 start when the trigger is pulled.
The blowgun stops when the trigger is released again.
• Always hold the blowgun rmly by hand to ensure correct function.
•Never use the blowgun for purposes for which it was not designed. This might destroy the blowgun.
•The performance of the blowgun depends on many factors:
If the air ow pressure is below 10 bar, performance will also be reduced.
Clogged air nozzle.

© Copyright – AirApp Power Tools GmbH • Siemensstr. 9 – 11 • 40885 Ratingen 3
Maintenance
The blowgun is virtually maintenance-free and only needs to be cleaned outside.
In the event that maintenance or repair should be required, observe the environmental regulations under local law.
To achieve a long lifetime, the manufacturer recommends professional maintenance by trained, qualied personnel of
your service partner.
If you have any questions, please contact the manufacturer.
Attention!
Repairs should only be carried out by the service partner of the manufacturer.
Disposal
When disposing of the device, comply with applicable local legislation. Remember that incorrect disposing of lubri-
cants causes environmental damage.
We accept no liability or warranty for damage or injuries resulting from improper use or misuse or failure to
comply with the safety information.
Use the device only for the applications described.
Any other use is prohibited.
PB10 - Blow / Suction by turn the valve 180°