AIRVINE WaveTunnel User manual

Airvine WaveTunnel™
Bracket Installation Guide

DEC 2022
USER GUIDES
WaveTunnel Bracket Installation Guide
Find the location on the ceiling where you’d like to install the WaveTunnel.
a. If mounting to a T-Bar ceiling, attach the T-Bar ceiling clips, and use the
¼-20 lock nuts to secure circular plate.
b. If mounting to a sheetrock celling, use 2 drywall anchors & screws to
secure the circular plate.
c. If you can locate a ceiling joist, use 2 wood screws to secure the circular
plate.
NOTE: Use the screw
holes located
opposite each other

DEC 2022
USER GUIDES
NOTE: Align the
threaded studs with
the curved slots in the
bracket.
Once you have the circular plate secured, lift the bracket into place and secure with
the provided thumb screws.

DEC 2022
USER GUIDES
Adjust the angle as needed, then re-tighten the thumb screws.

DEC 2022
USER GUIDES
If the WaveTunnel requires a power adapter, use the provided clip & screw to secure it
to the side of the bracket.
Power Adapter
Bracket

DEC 2022
USER GUIDES
Using the 4 keyhole slots, align and install the WaveTunnel to the bracket, by using
the 4 keyhole slots.
Remove the WaveTunnel by lifting the flex tab and sliding it forward, out of the
keyhole slots.