Akicon 98188 User manual

PACKING LIST
IMPORTANT NOTICES: For easy installation, please read all the instruction completely before beginning.
Before installing this product, make sure that water line trash is cleared to avoid blockage.
YOU MAY NEED
After you open this package, please check to ensure that all of the following items are included.
A - Faucet B - Mounting Assemblies C - Allen Wrench
1
EX: E002010T Rev: A
A
B
C
4
TROUBLE-SHOOTING
If you've followed the instruction carefully and your faucet still does not work properly, take these corrective steps.
Problem Cause Action
Leaks underneath handle. Cartridge has come loose. Tighten the cartridge.
Aerator leaks or has an
inconsisitent water flow
pattern.
Aerator is dirty or worn
out or misfitted.
Unscrew the aerator to
clean or replace washer,
or replace the aerator.
Water will not shut off
completely.
Dirty or worn out washer
in cartridge.
Remove handle and cartridge
to check if the washer is damaged
permanently or dirty. Re-install
cartridge.
CAUTION: Maintenance
1. Replacement parts may be available at the store where you purchased your faucet.
2. Always turn off water and relieve pressure before working on your faucet.
NOTES: Cleaning Instructions
1. To keep the faucet clean, you should clean the faucet frequently and regularly.
2. Clean the faucet with clear water or mild liquid, rinse the faucet with clear water and then
dry the faucet with soft cotton cloths.
3. Do not use any abrasive cleansers, cloths, or paper towel.
4. Do not use any acid or abrasive detergent.
Pot Filler Faucet
Questions, problems, missing parts?
call Akicon Customer Service 8 a.m.-6p.m. EST, Monday-Friday
Phone: [phone], Email: [email protected]
AKICONSHOP.COM
Model: 98188

3
Unscrew handle counter clockwise by hand, then unscrew
Screws using screwdrive, take out handle.
Remove handles. Unscrew Dome Cap counter clockwise
by hand. Unscrew Retaining Nut using adjustable wrench,
take out cartridge assembly and inspect. Replace parts
as necessary. Reassemble parts by reversing steps.
Handle Removal Maintenance Valve Cartridge Removal Maintenance
INSTALLATION PROCEDURES
You should clean all the dirts from valve outlets.
Turning off the water supply valves. This is usually
found near the water meter. If you are replacing
an existing faucet, remove the faucet from the
sink and clean the sink surface thoroughly.
Install without Deck Plate. Make sure the O-RING
is placed onto the bottom of Base Ring. Install
faucet through hole in sink. From underside sink,
put Plastic Washer and Mounting Nut. Position
faucet on sink properly and tighten Mounting Nut.
If necessary, tighten screws using a adjustable
wrench until the faucet is firmly connected to the
sink.
2
1 2
34
6
Turn both handles fully clockwise to the off position.
5
Use the flexible hose to connect the faucet to the water
supply valve. (Another purchase of flexible hose)
Turn on the water supply to the faucet and check for
leaks.
8
7
Remove the aerator and open both handles to flush
debris from the faucet.
Turn off the water and reinstall the aerator.