Aleko LM176 User manual

- 1 -
User Manual of Electromagnetic Lock
（Model：LM176）
☆Technical Parameters:
A. Holding power: 280KGS、B. Working Voltage: 24VDC
C. Working Current:250mA D. Safety mode: Power-on to lock, Power-off to open.
E. Typical Installation：Flushing（A）、 Hanging（G）
☆Installtion chart
Hanging Type Electromagnetic Lock Electromagnetic Lock fitting for all kinds of doors.
Flush Bonding Type
☆Typical Installation：
STEP 1
A．Fold template along dotted line.
B．Place template against door and head frame.
C．Drill holes as indicated on temple.
STEP 2
A．Mount the armature palte to door using 1 rubber washer sandwiched between 2 steel washer(the rubber washer and 2 steel washer are installed on the
through sexnut between the armature plate and door).
STEP 3
A．Install the mounting plate with 2 flat head screws(the 2 M5X5 flat head screws are installed in the solotted holes for adjustment).
B．Adjust mounting plate so that it forms right angle with the armature plate.
C．Using the mounting plate as a temple,drill the wire hole.
D．Drill and remaining mounting screws.
STEP 4
A．Instal magnet to mounting plate with 2 M4 screws supplied.
STEP 5
A．Test all functions of this model(see wiring instruction).
Model
L1
L2
A
B
D
E
F
280GF/X
250
210
27
16.5
2.3
6
50.5

- 2 -
☆Armature Plate Mounts To The Door：
Important：Fix the armature plate not too tightly, and make the rubber washer more flexible, in order to make the armature plate automatically adjust its
proper position with magnet.
☆Connection for 24VDC Kit：
A．Required power 0.5Amp（Maximum）. B. Connect the ground (-) lead of 24VDC power source to negative terminal of the E-lock .
C．Connect the positive (+) of 24VDC power source to positive terminal of the E-lock .
☆Connection With AS/GG swing gate opener：
☆Other installtion