Alert-it Pulse Companion User manual

How to turn on the armband
To turn on the armband press and hold the power button
for 5seconds.
Adjust the sensor strap and fit where appropriate.
Instructions for use
Thank you for purchasing the
Pulse Companion
Using the Pulse Companion
How to turn on the pager
Turn on the pager by pressing and holding the menu
button for 3seconds a pip noise will sound.
Pulse 00 should appear on the screen every 8 seconds
after start up.
How to turn on the Pulse Companion
To turn on the Pulse Companion, press and hold
•••button for 3seconds.
The Pulse Companion will automatically pair to the
armband supplied with this equipment.
The LED will flash green rapidly when connecting.
The LED on the Pulse Companion will now flash green
every 4 seconds, you are now in monitoring conditions.
Press and hold
for 5 seconds
Press and hold
•••button for
3seconds
Status lights
Adjust strap for
optimal fit and
performance
Green LED will flash
to confirm connection
Press and hold until
screen turns on
“Battery“ or “charging“
will appear in normal
mode.
“Pulse 00” will
appear onscreen

Instructions for use
2. How to put the Pulse Companion and pager into Standby
Press and hold the •••button for 3seconds.
After six minutes, fault 26 will clear and LED will Blink Red every 4seconds indicating the
Pulse Companion is now in standby.
Fault 26 will now clear from the pager and will be alternating between battery and Pulse 00.
1. How to turn o the armband
To turn o the armband hold the power button for
5seconds.
Remove the armband when convenient.
Power Button
Status lights
Loosen strap to remove
once powered down
How to disconnect the armband
“Battery” and “Pulse00”
will alternate onscreen
“Fault 26” will
appear onscreen once all
LED’s on armband are o
Press to silent the
fault alarm
•••button
LED will Blink Red
every 4seconds
LED will flash
RED when
disconnected
Domestic Environment Only
For quick disconnect go to the advance
settings to enable and save changes.
Pager will now clear Fault 26 within 5 seconds
by holding •••button for 3 seconds. UQ1484