Alesis QuadraVerb 2 Specification sheet

QUICK SETUP
n Connect your source (instrument, mic, mixer) to either of
MIDIVERB II's inputs; both inputs if you have a stereo signal.
n Connect the MIDIVERB II outputs to your instrument amp(s)
or stereo mixer returns.
n Set the MIX control to 50/50
n Start the source signal.
n Turn the INPUT control clockwise until the green SIGNAL
LED stays on (when signal is
present) and the red OVLD
(overload) LED flashes occasionally on peaks.
n Turn the OUTPUT control clockwise to the volume level you desire.
n Change Programs manually by pressing any two numbered
buttons 00-99
n Set the MIDI receive channel: Press CHAN followed by two
numbered buttons 01-l 6.
n Assign Programs to MIDI Patch numbers:
Press PATCH followed by two numbered buttons 01-32.
Press PRGM followed by two numbered buttons 00-99
Hold STORE and press PATCH.
n The system always reverts to Program mode (PRGM LED on).