Algo 8188 User manual

Algo 8188 SIP Ceiling Speaker
Note: This guide applies to HPBX 3.0
1. Locate the device IP Address on the network and login from any web browser with the following url
format: http://192.0.0.0
a. The above IP is only an example.
b. The default password is “algo” and this will also appear on the intro screen after you have
accessed the device successfully via the web browser.
2. Log into the device with the default password provided.

Algo 8188 SIP Ceiling Speaker
3. Click on > Basic Settings tab > SIP tab.
a. SIP Domain (Proxy Server): hpbxX.telecomsvc.com
i. “X” will be substituted with the customers registration server number.
b. Ring/Alert Mode: click on the radio button “Monitor “Ring” event on registered SIP extension.
c. Ring Extension: enter the SIP registration ID.
d. Authentication ID: enter the SIP registration ID.
e. Authentication Password: enter the SIP registration password.
f. Page Extension: enter the SIP registration ID.
g. Authentication ID: enter the SIP registration ID.
h. Authentication Password: enter the SIP registration password.
i. Click SAVE
4. Click on > Advanced Settings tab > Network tab
a. Differentiated Services
i. SIP: 26
ii. RTP: 46
iii. RTCP: 46
iv. Click SAVE

Algo 8188 SIP Ceiling Speaker
5. Navigate to the next sub tab > Advanced Audio
a. Jitter Buffer Range: change to 150
6. Navigate to the next sub tab > Advanced SIP
a. SIP Transportation: UDP
b. SDP SRTP Offer: Disabled
c. SIP Outbound Support (RFC 5626): Disabled
d. Outbound Proxy: hpbxX.telecomsvc.com
i. “X” will be substituted with the customers registration server number.
e. Register Period (seconds): 300
f. Keep-Alive Method: Double CRLF
g. Keep-Alive Interval (seconds): 15
h. Click SAVE.
7. Navigate back to the Status tab and check that the device is registered.
a. If the device is not registered, recheck the following:
i. Sever entered
ii. Sip credentials
iii. Try rebooting the device
iv. Try rebooting the network.
User guide: Algo8188 SIP Ceiling Speaker FW Version 1.5