Altelix BMP-EER2 User manual

BMP-EER2
Installation Guide
Altelix LLC USA: 866-660-WIFI (9434) International: [phone] [email protected] www.altelix.com
Copyright (C) 2023 Altelix LLC. All rights reserved. Altelix and the Altelix logo are Trademarks and/or Registered Trademarks of Altelix LLC.
Specifications are subject to change without notice. See www.altelix.com for most current information
eero® is a trademark or registered trademark of Amazon Technologies, Inc.
IS0210 Rev A 07/10/23

BMP-EER2 Installation Guide
The BMP-EER2 can be directly mounted to the inside of a network equipment
cabinet using the included double-sided tape. For wall mounting, wall anchors
and screws are also provided.
Double Sided Tape
(Optional Step) For installations subject to
vibrations, an optional hook and loop strap is
provided to secure the eero Pro 6 in the
mounting cradle.
Wall Anchors and Screw
To use the included double-sided tape,
firmly attach to the rear of the BMP-EER2
as shown.
For wall mounting use the drill template
below.
Once the BMP-EER2 is mounted, insert
the eero Pro 6 into the cradle as shown.
Hook and Loop Strap
Drill Template for Mounting Holes
Place the template in the desired
mounting location and mark the holes.
Follow all applicable safety precautions
when drilling. If necessary, drill pilot holes
where you made your mark. If you will be
using the wall anchors provided with your
enclosure drill 3/16 inch holes. If you will be
using the screws directly, drill 3/32 inch
holes.
Printing Instructions
Print onto 8-1/2” x 11” paper. Select
“Actual Size” or “100% Scale” when
printing.
Installation Note: If attaching to surfaces such as glass, mirror and tile, be sure to clean
surfaces first with alcohol wipes or glass cleaner
IS0210 Rev A 07/10/23