Altronix Trove1R User manual

Trove1R
Combine Altronix Power and Accessories with
Access Controllers from the Industry’s Leading
Manufacturers in a 2U rack enclosure
Access & Power Integration
Rev. 082420 More than just power.TM
Installing Company: _______________ Service Rep. Name: __________________________________
Address: _____________________________________________ Phone #: __________________
Installation Guide
SIGNALING
All registered trademarks are property of their respective owners.

- 2 - Trove1R Installation Guide
Overview:
Trove1R accommodates various backplanes (Txx1R) which allow for combinations of access controllers and ac-
cessories from the industry’s leading manufacturers with or without Altronix power supplies and accessories for
access systems. A variety of backplanes offer a wide range of scalable access and power configurations. Trove1R
simplifies board layout and wire management, while reducing installation and labor costs. Model Trove1R is an en-
closure only, not evaluated with accessory/subassembly board configurations.Txx1R has not been evaluated by UL.
Trove Model Identification:
Series Trove Rack
Enclosure Size
Backplane Model
(Access Controller Manufacturer) Backplane Size
Trove
1
3.25” x 19.0” x 26.5”
(82.6mm x 482.6mm x 673.1mm)
AG = AMAG
1R
18.5” x 15.25” x 0.375”
(469.9mm x 387.4mm x
9.5mm)
AL = Altronix
BH = Bosch
BL = Universal Blank Backplane
CV = CDVI
DM = DMP
HH = Hirsch
HN = Honeywell NetAXS
HW = Honeywell ProWatch/WinPak
KA = Keyscan
KH = Kantech
M= Mercury
PX = Paxton
SA = Salto
SH = Software House
SL = Sielox
V= HID/VertX
Z= ZKTeco
X or XX = May be letters A-Z,
where X or XX represents
stud pattern

Trove1R Installation Guide - 3 -
Specifications:
Agency Listings:
• UL 294 - 7th edition. Trove1R Power Controllers: Destructive Attack I.
• This Class B digital apparatus complies with Canadian ICES-003.
Cet appareil numérique de la classe B est conforme á la norme NMB-003 du Canada.
• CE European Conformity.
Environmental:
• Humidity and Temperature conditions as tested by UL: (85%, +/-5% @ 30ºC +/-2ºC),
ULC: (93%, +/-2% @ 32ºC +/-2ºC).
Battery Backup:
• If batteries are being used in your installation do not fit into the Trove1R unit, it is required to install a separate
enclosure, UL Listed for appropriate application. Separate battery enclosure is required to have 50 cubic
inches of additional open space. All wiring methods shall be in accordance with the National Electrical Code
NFPA 70/NFPA 72/ANSI and with all local codes and authorities having jurisdiction. Battery circuits are not
power-limited; provide 0.25” spacing from power-limited circuits and use separate knockout. If additional
battery enclosure is required, it must be UL Listed for the application and mounted within 5’ of the Trove1R
enclosure in the same room; minimum 12 AWG wire in appropriate conduit is required for connection. When
using conduit, make sure it is installed in a matter where it can not turn.
Additional Features:
• 16 Gauge enclosure with ample knockouts for convenient access.

- 4 - Trove1R Installation Guide
Installing Trove1R into Rack Tower:
Wiring methods shall be in accordance with the National Electrical Code/NFPA 70/ANSI, and with all local
codes and authorities having jurisdiction. These products are for indoor use only and must be installed within
the protected premises.
Note: First assemble and Install Z Bracket Wire Management Accesory
(refer to Z Bracket Installation pg. 4)
1. Remove backplane from enclosure prior to installing into rack cabinet
(do not discard hardware).
2. In order to mount included UL Listed tamper switch (Altronix Model TS112 or
equivalent) turn the enclosure upside down. Punch out the knockout in
designated location, on the back of the unit, from outside of the drawer
(Fig. 1, pg. 4). Insert the tamper switch into the knockout from outside of the
drawer with the button facing outwards and spaded connectors inside the drawer.
Connect tamper switch wiring to the Access Control Panel input or the
appropriate UL Listed reporting device.
To activate alarm signal open the rack drawer.
3. Slide the rack enclosure into an open 2U location in the four post rack cabinet.
4. Utilizing proper fasteners attach front ears to the rack rails (Rack drawer, pg. 20).
5. Attach the rear of the adjustable slides to the rear rails of the rack cabinet with the proper fasteners.
6. Secure the rack cover (Fig. 2a, pg. 4) and rack drawer (Fig. 2b, pg. 4) to earth ground.
7. Ensure that all internal cofigurations (voltage selection, switch settings, etc.) are completed before
mounting backplane back into Trove rack enclosure.
Fig. 1
Back of the drawer,
viewed from outside.
Tamper Switch
mounting location
Fig. 2
Fig. 2a
Fig. 2b

Trove1R Installation Guide - 5 -
Z Bracket Installation for Trove1R:
Altronix Trove1R enclosure includes Z Bracket, a convenient and reliable wire management accessory.
Hardware (included):
Ten (10) bolts and eight (8) lock nuts.
1. Carefully unpack Z Bracket. Do not discard hardware
(included) (Fig. 3, pg. 5).
2. Attach arms to each other using bolts and
lock nuts (Fig. 3a, pg. 5).
3. Attach the hinge brackets to the ends of
arms using bolts and nuts positioning
them as shown on (Fig. 3b, pg. 5).
4. Make sure that all nuts are tightened.
5. Attach the hinge bracket on the longer side of Z Bracket to the adjustable slide using bolts and lock nuts
(included) (Fig. 4, 4a, pg. 5).
6. Attach the hinge bracket on the shorter side of Z Bracket to the rear of the rack enclosure using bolts
(included).
Fig. 4
Fig. 4a
Fig. 3b
Two (2)
Fig. 3
Fig. 3a

- 6 - Trove1R Installation Guide
Notes:

Trove1R Installation Guide - 7 -
Notes:

- 8 - Trove1R Installation Guide
Trove1R Enclosure Dimensions:
3.375” x 19.0” x 26.5” (85.8mm x 482.6mm x 673.1mm). Shown with Z Bracket attached.
0.1”
2.5mm
1.5”
38.1mm
11.175” (283.8mm)
2.4”
61mm
4.57”
116.1mm
3.375”
85.8mm
26.5”
673.1mm
19” (482.6mm)
R 1.27” (32.3mm)
1” (25.4mm)
0.55” (14mm)
3.62”
92mm
Altronix is not responsible for any typographical errors.
––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––
140 58th Street, Brooklyn, New York 11220 USA | phone: [phone] | fax: [phone]
website: www.altronix.com | e-mail: [email protected] | Lifetime Warranty
IITrove1R H31U MEMBER