Altronix TROVE PLUS T3MB777K1 User manual

T3MB777K1
24 Door Kit with Fused Outputs
Accommodates one (1) Intelligent Dual Reader Controller and
eleven (11) Dual Reader Interface Modules.
Each fully assembled kit includes:
- Trove3 enclosure with TM3B Altronix/Mercury backplane
and 36 BR3M mounting brackets.
- Three (3) eFlow104NB - Power Supply/Chargers
- Three (3) ACMS8 - Dual Input/Output Fuse Protected
Access Power Controllers
- Three (3) PDS8 - Dual Input/Output Fuse Protected
Power Distribution Modules
- Two (2) Rocker Switch Brackets with
Three (3) Rocker Switches (Not evaluated by UL)
- Wire harnesses and management
T3MB777K1D
24 Door Kit with PTC Outputs
Accommodates one (1) Intelligent Dual Reader Controller and
eleven (11) Dual Reader Interface Modules.
Each fully assembled kit includes:
- Trove3 enclosure with TM3B Altronix/Mercury backplane
and 36 BR3M mounting brackets.
- Three (3) eFlow104NB - Power Supply/Chargers
- Three (3) ACMS8CB - Dual Input/Output PTC Protected
Access Power Controllers
- Three (3) PDS8CB - Dual Input/Output PTC Protected
Power Distribution Modules
- Two (2) Rocker Switch Brackets with
Three (3) Rocker Switches (Not evaluated by UL)
- Wire harnesses and management
Altronix/Mercury Wired Kits
Models Include:
Rev. T3MB777K1_051823
Installing Company: _________________________ Service Rep. Name: __________________________________________
Address: _________________________________________________________ Phone #: _________________________
All registered trademarks are property of their respective owners. More than just power.™
Installation Guide
All components of these Trove kits are UL Listed sub-assemblies.
Please refer to the included corresponding Sub-Assembly Installation Guides for further information.
Access & Power Integration

- 2 - T3MB777K1 Kit Series Installation Guide
Overview:
Altronix Trove Plus kits are pre-wired, pre-assembled and consist of Trove3M3 enclosure/backplane with factory installed Altronix power supply/chargers and
sub-assemblies, wire harnesses and finger duct.
Configuration Chart:
Altronix
Model Number 120VAC 60Hz Input Current (A) Power Supply Board Input Fuse Rating Power Supply Board Battery Fuse Rating
Nominal DC Output
Voltage Range
Maximum Supply Current
for Main and Aux. Outputs
on Power Supply board and
ACMS8(CB) Access Power
Controller’s outputs Fail-Safe/Fail-Secure or Dry Form “C” Outputs Current Per ACMS8(CB) and PDS8(CB) Output (A) ACMS8(CB) Board Input Fuse (PTC) Rating ACMS8(CB) Board Output Fuse (PTC) Rating PDS8(CB) Board Input Fuse (PTC) Rating PDS8(CB) Board Output Fuse (PTC) Rating
Power
Supply
1
Power
Supply
2
Power
Supply
3
Output
Range
(VDC)
Output
Range
(VDC)
Output
Range
(VDC)
T3MB777K1
13.5 6.3A/
250V
15A/
32V
20.17-
26.4
20.17-
26.4
20.17-
26.4 24VDC @ 9.4A 24
2.5 15A/
32V
3A/
32V
10A/
32V
3A/
32V
T3MB777K1D 2.0 9A 2.5A 9A 2.5A
Hardware and Accessories:
• Two (2) tamper switches (Altronix Model TS112 or equivalent).
• Cam lock.
• Battery leads.
Mechanical:
• 16 Gauge enclosure with ample knockouts for convenient access.
• Enclosure Dimensions (H x W x D): 36.12” x 30.125” x 7.06” (917.5mm x 768.1mm x 179.3mm).
Installation Instructions:
Enclosure Mounting:
Wiring methods shall be in accordance with the National Electrical Code/NFPA 70/ANSI, and with all local codes and authorities having jurisdiction.
Product is intended for indoor use only.
1. Remove backplane from enclosure. Do not discard hardware.
2. Mark and predrill holes in the wall to line up with the top three keyholes in the enclosure. Install three upper fasteners and screws in the wall with the
screw heads protruding. Place the enclosure’s upper keyholes over the three upper screws, level and secure. Mark the position of the lower three holes.
Remove the enclosure. Drill the lower holes and install the three fasteners. Place the enclosure’s upper keyholes
over the three upper screws. Install the three lower screws and make sure to tighten all screws.
3. Mount included UL Listed tamper switches (Altronix Model TS112 or equivalent) in desired location,
opposite hinge. Slide the tamper switch bracket onto the edge of the enclosure approximately 2” from
the right side (Fig. 1, pg. 2). Connect tamper switch wiring to the Access Control Panel input or the
appropriate UL Listed reporting device. To activate alarm signal open the door of the enclosure.
Installing and Connecting Lenel/Mercury Modules:
4. Altronix power supplies and sub-assemblies are factory installed and wired.
Refer to the eFlow Power Supply/Charger Installation Guide for eFlow104NB and corresponding
Sub-Assembly Installation Guides for PDS8(CB) and ACMS8(CB) for further installation instructions.
5. Position Lenel/Mercury access controller modules over corresponding spacers and depress onto
factory installed snap on spacers on the brackets (Fig. 2, pg. 3). When mounting Lenel/Mercury
modules, start with the bottom to facilitate easy mounting.
6. Connect wire harnesses to Lenel/Mercury access controller modules (Fig. 2, pg. 3).
7. Mount backplane to enclosure with hardware.
Fig. 1
Tamper Switch
(included)
To Access Control Panel or
UL Listed Reporting Device
Edge of
Enclosure
Enclosure

T3MB777K1 Kit Series Installation Guide - 3 -
T3MB777K1(D) Configuration:
1. Position access controller module over corresponding spacers and depress onto snap on spacers (Fig. 2, pg. 3).
2. Mount backplane to enclosure with hardware.
Access Controller Position Chart for the Following Models:
LenelS2 / Mercury Access Controller Pem Mounting
LNL-2220 / LP1502 E
LNL-1320-S3 / MR52 A B C D F G H
Fig. 2
Altronix eFlow104NB
Altronix eFlow104NB
Altronix eFlow104NB
Altronix
ACMS8(CB)/PDS8(CB)
Altronix
ACMS8(CB)/PDS8(CB)
Altronix
ACMS8(CB)/PDS8(CB)
RSB2
RSB1
LP1502 MR52
MR52MR52
MR52MR52
MR52MR52
MR52MR52
MR52MR52

- 4 - T3MB777K1 Kit Series Installation Guide
Trove3 Enclosure Dimensions (H x W x D approximate):
36.12” x 30.125” x 7.06” (917.5mm x 768.1mm x 179.3mm)
G
G
2”
(50.8mm)
8.75” (222.3mm) 8.75” (222.3mm)
8.62” (219mm)
7.06” (179.3mm)
1.25” (31.8mm)
1.25” (31.8mm)
2.00” (50.8mm) 7.12” (222.3mm) 9.5” (241.3mm) 9.5” (241.3mm)
30.12” (768.1mm)
14.01” (355.9mm) 14.01” (355.9mm)
1.25” (31.8mm) 1.55” (39.4mm)
1.78” (45.2mm)
1.25” (31.8mm)
1.07”
(27.2mm)
1.10” (27.9mm)
2” (50.8mm)
10.75” (273.1mm)10.75” (273.1mm) 10.62” (269.8mm)
2.00” (50.8mm)10.75” (273.1mm)10.75” (273.1mm) 10.62” (269.8mm)
36.12” (917.5mm) 33.63” (854.2mm)
2” Conduit
3/4” Conduit
1” Conduit
3/4” Conduit
1” Conduit
1.5” Conduit
1.25” Conduit 1.5” Conduit
1.25” Conduit
3/4” Conduit
1” Conduit
3/4” Conduit
1” Conduit
Altronix is not responsible for any typographical errors. Product specifications are subject to change without notice.
––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––
140 58th Street, Brooklyn, New York 11220 USA | phone: [phone] | fax: [phone]
website: www.altronix.com | e-mail: [email protected] | Lifetime Warranty
IIT3MB777K1 Kit Series E18W MEMBER