Alva G001B User manual

IMPORTANT SAFETY INFORMATION
As with all gas appliances, misuse of this appliance or failure
to fully follow these instructions may cause injury or death.
Please read all the instructions before using your hotwheel.
• Please read these instructions carefully before installing and
using your hotwheel.
• The operator must understand all safety requirements as
in this manua’l before using the unit.
• The operator is responsible for the safety of all third parties
while the appliance is in use.
• The manufacturer’s warranty will be voided by incorrect use of
this product.
• If you have any queries regarding these instructions, contact
your local dealer for before you use your hotwheel.
• The unit must be correctly installed before use.
• Failure to follow the manuals instructions could result in damage
or serious injury.
• DO NOT use indoors. The hotwheel is designed for
OUTDOOR USE ONLY.
• Ensure that the hotwheel is positioned on an even and secure
surface before operating.
• Leak test all gas lines and connections before use.
• DO NOT store materials near the hotwheel.
• DO NOT place or use aerosol sprays near the hotwheel.
• Use only with LPG gas.
• DO NOT leave the hotwheel unattended when it is alight.
• Onlookers should keep a safe distance away from the
hotwheel when it is in use.
• Keep children and animals well away while the hotwheel is in
use.
• Parts of the hotwheel will get extremely hot and could cause
serious burns - test every surface before touching it.
• Be very careful when operating the hotwheel. The operator
should pay constant attention to the food being cooked and
should remain at the appliance at all times when it is lit.
• Ensure that the gas supply is turned OFF after use and while
the hotwheel is unattended.
• Neither the manufacturer nor their Agents can accept any
liability for the unsuitability of, or any damage to, any food
cooked on this appliance.
• Modifying or tampering with any part of this hotwheel is illegal
and unsafe and will void your warranty.
Please read the
instructions carefully
before use.
Retain this manual for
future reference.
• DO NOT use this appliance in an enclosed area, which could
restrict airflow. Always make sure there is enough fresh air
entering the room, by opening a door or window in the same
room.
Thank you for your
purchase of this
product.
Please read these
instructions carefully
before use and keep
them in a safe place,
for future reference.
Not using gas and/
or gas appliances
according to the
instructions is
extremely dangerous
and can lead to
property damage,
injury or death.
detailed

1. Before screwing the stem pipe (F) into the cradle (B), check if the sealing
washer (E) is in position.
2. Screw the stem pipe into the cradle. Secure properly.
3. Clean the cylinder valve by blowing out or brushing with a small paint brush.
Failure to do this may result in the blockages in the jets.
4. Screw the stem/cradle assembly into the cylinder, ensuring a gas tight seal.
5. Place the cylinder on a at sturdy surface.
6. Place the cast iron top on the cradle upright and brush the side of the cast iron
plate you wish to use lightly with the cooking oil of your choice.
7. Perform a “Leak test” as specied below.
8. (Always light the cast iron plate (A) in position).
Strike a match, open the cylinder valve slightly and light one of the 3 burners.
The 2 remaining burners will ignite within 5 seconds.
9. If one or both of the burners do not ignite within 5 seconds, inspect burner jets
for blockages. Repeat procedure.
If the problem persists contact your dealer for assistance.
Once all 3 burners are alight, open cylinder valve to medium setting.
An even roaring sound will be heard - this is normal.
Open the gas control at the cylinder and ignite the hotwheel.
Using a 50/50 water/soap solution, wipe or spray over the connection at
the top (G) and at the top (E) of the stem pipe (F).
If bubbles form on the connection/joint, then there is a leak.
Turn o the gas supply at the cylinder.
Tighten again and redo the leak test described above.
If the leak persists, replace the sealing washers.
If the leak persists, contact your local gas dealer to check.
NEVER USE A OPEN FLAME TO TEST FOR LEAKS.
METHOD OF ASSEMBLY.
HOW TO CHECK FOR LEAKS.

burns inside
the burner, instead of outside, the burner will make a roaring sound and turn red):
• Immediately turn OFF the gas supply at the cylinder
• Once cooled down, check the jet for blockages. If blockages are found, clear with
compressed air or with a pipe cleaner.
consult your dealer as the burner might have to be replaced.
DO NOT use this appliance for anything other than that for which it is
intended.
DO NOT place heavy pots etc. directly on to the burner. All cooking pots,
pans, etc. must rest on the 3 upright arms. When in use, ensure that the
materials (at least 1000mm).
WARNING
PLEASE DO NOT TAMPER WITH JET SIZE BY OPENING WITH A SHARP OBJECT
TO TRY TO MAKE THE JET HOLE BIGGER.
Not only is this dangerous, but will also nullify your warranty.
MAINTENANCE
On a regular basis, checks and maintenance should be done.
You can carry out these checks and maintenance yourself.
• Fibre washers (E) and (G) are available from your local gas dealer.
Replacement at yearly intervals is recommended.
Always check that the washers are sound and in position everytime
your hotwheel is used.
• If poor performance is observed, one or more of the jets (D) may be blocked.
Remove burner (C) by unscrewing it.
Remove jet (D) and clean jet by blowing with compressed air.
Replace if necessary.
Jets are available from your local gas dealer.
Tighten jet properly when replacing, and put burner cap back in position.
If your cylinder or Hot Wheel is faulty, please consult your dealer.

ACCESSORIES FOR HOTWHEEL
1. Maluti Flat Bottom Pan.
2. 3 Division Breakfast Pan
(To be used in conjunction with a set of extension brackets.)
3. Heavy Duty Carry Case sold separately.
BBQ HINT:
For steak, preheat the plate for at least 5 minutes
Place the steak on to the heated top for 2 minutes
For medium rare, allow to cook for 2 minutes and turn
Other preferences will take longer
It is not necessary to preheat the top for wors, poultry or sausages.
Pork and lamb can be cooked the same as steak, but on a gentler heat setting
and with slightly longer turning times.

G001B ASSEMBLY AND PART LIST
AReversible cast iron top
B Cradle unit
C Burner x 3
D Jet (0.24mm) x 3
E Washer
F Stem pipe
G Washer
H Adaptor x 3
WARNING:
It is illegal and dangerous to change or modify any part of this appliance.
TECHNICAL DATA
MODEL NO.: G001B
DESCRIPTION: 3 BURNER HOTWHEEL WITH REVERSIBLE CAST IRON PLATE
GAS CONSUMPTION (AT MAX): 630 gr/hr
TYPE OF GAS: LPG
BURNERS: 3
WARNING: ACCESSIBLE PARTS MAY BE VERY HOT. KEEP YOUNG CHILDREN AWAY.
CONTACT ALVA
MANUFACTURED FOR AND DISTRIBUTED BY
Alva, a division of Stingray Accessory Manufacturers (Pty) Ltd.
P.O. Box 30014
Tokai, 7966
Tel: [phone]
E-mail: [e-mail]
www.alva.co.za
/alvagas
www.facebook.com/AlvaGas
TOLL FREE NUMBER
086 100 ALVA (2582)