Amart Furniture MAPLETON 72748 User manual

ASSEMBLY INSTRUCTION
MAPLETON KING BED
ITEM CODE 72748
Imported by Amart Furniture Pty Ltd, Qld, Brisbane Australia.
For any assistance with assembly or for missing parts please phone
Amart Furniture, Customer Service Free call 1800 351 084
1
1200mm
1960mm
2260mm
72748

2
PRE-ASSEMBLY PREPARATION
Before you start:
1. Choose a clean, level, spacious assembly area. Avoid hard surfaces that may
damage the product
2. Take care when lifting. Product should be assembled as near as possible to
the point of use
4. Always read the assembly instructions carefully before beginning assembly.
5. Keep all hardware parts and packaging out of reach of small children.
6. Do not over tighten the screws and bolts as this may damage the threads
3. Ensure that you have all required contents for complete assembly
72748

3
PARTS LIST
2
3
4
5
Middle rails
2 pcs
6 pcs
1 Headboard 1 pc
Side rail
2 pcs
3 pcs
NO. PARTS LIST QT'Y
Support legs
Middle Slats
Footboard 1 pc
Bolt M6x60mm 6 pcs
NO. HARDWARE LIST QT'Y
B
C
Screw M4x30mm 24 pcs
D
Allen Key 4mm 1 pc
6
A
Bolt M8x80mm 8 pcs
12 pcs
Slats
7
6 pcs
E
Adhesive felt pad
Ø20x5
7
7
6
3
3
1
4
5
5
5
5
5
5
2
L
Wrench 1 pc
Bolt M6x35mm 6 pcs
F
G
Half moon washer 8 pcs
H
I
8 pcs
8 pcs
Spring washer
Hex nut
K
72748
Wooden Dowel 8 pcs

STEP 1: Attach adhesive felt pad (L) onto the legs.
4
L
2
Attach side rails (3) onto headboard (1) and footboard (2) using the bolts (C), half moon washer
(D), spring washer (E) and hex nut (F), tighten it up by using a wrench (I).
1
L
(x8)
D
EF
1
2
3
3
I
C
C
K
72748
STEP 2: Attach wooden dowel (K) and the bolts (C) onto headboard and footboard.

5
STEP 3: Attach support legs (5) onto middle rails (4) and middle slats (6) using the bolts (A),
tighten it up by using an allen key (H).
Assemble these components out of bed frame.
STEP 4: Use two people to place Y frame onto side rails (3).
Attach Y frame onto side rails (3) using the bolt (B), tighten it up by using an allen key (H).
Y frame
6
5
5
5
5
5
5
H
A(x6)
H
B (x6)
3
3
Y frame
4
72748

6
. DO NOT push or pull the bed if there is a need for re-positioning as this may result in broken
support legs for the centre rail.
IMPORTANT NOTE:
STEP 5: Once the bed is positioned and the support legs are adjusted to touch floor,the slats
can then be laid down and secured before putting on the mattress.
Attach slats (7) onto side rails (3) using the screws (G), tighten it up by using a screwdriver.
ASSEMBLY IS COMPLETE
7
7
G
(x24)
3
3
72748

suitable
and sudden