Amart Furniture TULUM 72537 User manual

ASSEMBLY INSTRUCTION
TULUM BUFFET
ITEM CODE - 72537.
Imported by Amart Furniture Pty Ltd,Qld, Brisbane Australia.
For any assistance to assemble or for missing parts please phone
Amart Furniture, Customer Service Freecall 1800 351 084.
Imported by Amart Furniture Pty Ltd,Qld, Brisbane Australia.
For any assistance to assemble or for missing parts please phone
Amart Furniture, Customer Sece Frerviecall 1800 351 084.
72537
1600
430
810
1

272537

1. Attach one Mounting Plate to the wall with the Large Screws. Make sure to attach the
Mounting Plate into a stud. If mounting into brick or masonry you will need to acquire
wall anchors.
2. Attach the second Mounting Plate to the furniture frame with the Short Screws.
3. Move the furniture to its final position. Thread a Wall Strap through the both Mounting
Plates and tighten until snug. Do not over tighten.
NOTE
·This product must be fixed to a wall.
·As wall materials vary, screws and wall fixings are not always included.
·Make sure fixings are attached to a wall stud.
·If mounting onto brick or masonry you will need to acquire wall anchors.
·Consult your local hardware specialist on what wall fixing is appropriate.
·Check for plumbing or electrical wiring behind wall surfaces before commencing.
Ensure the correct wall fixings are used. Failure to do so may result in personal injury or cause
property damage if the product topples over.
SAFETY BRACKETS INSTRUCTIONS
Small Screw x 4Large Screw x 4
Wall Strap x 2
Mounting Plate x 4
HARDWARE
72537
3

ASSEMBLY IS COMPLETE
4
72537
! As wall materials vary,
screws for fixing to wall
are not included.
For advice on suitable
screw systems, contact
your local specialised
dealer.

care and maintenance
Congratulations! You have just purchased a quality product from
Super Amart, Australia’s largest discount furniture retail store. Please
read on for important information regarding your purchase…
A multi-step finish is applied to all our furniture, but all wood comes from nature.
Because of this, there will be natural variations in surface texture and grain like
knots, mineral streaks and sap runs that may affect the finish.
These differences in character are not defects, but distinctions that make each
piece of furniture unique.
Our furniture is built to last. Following these steps for basic care should protect
your investment for years to come.
„Dust frequently with a clean damp lint-free cloth. This will help remove
abrasive build up which can damage a finish over time.
„Do not place hot objects on any furniture surface. Always use a hot plate or
placemat. Laminate and lacquer finishes on table tops provide added scratch
and heat resistance to our furniture, but they can still be damaged without
proper care.
„Avoid exposing your furniture to strong sunlight, heat outlet, open windows or
dampness. Prolonged exposure to direct sunlight can fade the finish of your
furniture, while extreme temperature and humidity changes can cause
cracking or splitting.
„Do not expose your furniture to any liquids. Never allow water to sit on your
furniture. Alcohol, nail polish and perfume are also dangerous as they will
dissolve the lacquer finish on contact and may require professional repairs.
„Do not allow plastic to come in direct contact with your furniture. Chemicals in
the plastic of placemats etc may soften and mark the finish if left in contact
with the furniture for a period of time.
5