Amazfit Neo User manual

Amazfit Neo
User Manual

01 Packing List
Watch (strap included) Charging Base User Manual
BACK
SELECT
Heart rate sensing area
UP
DOWN
Charging port
Note: If turning on the watch by holding the power button doesn't work,
charge the watch and try again.
02 Product Introduction

Power on: press and hold the SELECT button for about 2 seconds until the
watch is powered on.
Confirm: press the SELECT button.
Page up: press the UP button.
Page down: press the DOWN button.
Cancel: press the BACK button.
Activate the backlight: press and hold the BACK button for about 2 seconds.
Pause/continue exercise: press the SELECT button in exercise mode.
Stop exercise: press the BACK button when exercise is paused.
Find phone: press and hold the BACK and UP buttons for about 2 seconds.
Restart: press and hold the SELECT and UP buttons for about 2 seconds until
the watch restarts.
Factory reset: press and hold the BACK and DOWN buttons for about 2
seconds. When the confirmation page appears, press the SELECT button to
confirm factory reset or press BACK to cancel.
View certification information: press and hold the SELECT and DOWN buttons
for about 2 seconds and view certification information on the Supervision
page.
Alarm
Feature Icons
Weekday
Feature Values
Date
Time (AM/PM
displayed only
in 12-hour mode)
Do Not Disturb
Disconnection Status

Use your phone to scan the QR code to the right to download and install the
app.
Notes:
1.
2.
For a better experience, update the app to the
latest version.
The system requires Android 5.0 or iOS 10.0 or
later.
03 Installing the App
04 Pairing the Watch
1.
2.
3.
Start the app and log in or register an account.
Press and hold the SELECT button to power on the watch.
Choose Profile > My Device > Add the app, add Amazfit Neo, and press the
SELECT button to confirm the pairing and complete pairing as prompted by
the app. The watch will display the correct time after it is paired.

Notes:
1.
2.
3.
Use the original charging base and ensure the charging port is dry.
Align the metal contacts of the charging base to the positioning groove of
the watch and ensure that the watch is securely fastened.
Connect the USB port to a mobile phone charger with an output current
above 500 mA or a computer USB port.
Use the original charging base to charge the watch. Connect the watch to
the charging base with the charging port of the watch aligned to the metal
contacts of the charging base. The charging image is displayed when
charging starts.
05 Charging the Watch
Model: A2001
Battery capacity: 160 mAh
Input: 5V 500mA
Wireless connection: Bluetooth 5.0 BLE
Water resistance rating: 5 ATM
Functional ambient temperature: 0°C-45°C
System requirements: Android 5.0 or iOS 10.0 or higher
06 Basic Parameters

07 Regulatory notice
This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that
may cause undesired operation.
FCC ID: 2AC8UA2001
Note: This product has been tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This product generates, uses, and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this product
does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following measures:
— Reorient or relocate the receiving antenna.
— Increase the separation between the equipment and receiver.
— Connect the equipment into an outlet on a circuit different from
that to which the receiver is connected.
— Consult the dealer or an experienced radio/TV technician for help.
The device has been evaluated to meet general RF exposure requirement. The
device can be used in portable exposure condition without restriction.
Please take attention that changes or modification not expressly
approved by the party responsible for compliance could void the user’s
authority to operate the equipment.

This device complies with Industry Canada licence-exempt RSS standard(s).
Operation is subject to the following two conditions:
(1) this device may not cause interference, and
(2) this device must accept any interference, including interference that may
cause undesired operation of the device.
IC: 21806-A2001 CAN ICES-3(B)/NMB-3(B)
Le présent appareil est conforme aux CNR d'Industrie Canada applicables
aux appareils radioexempts de licence. L'exploitation est autorisée aux deux
conditions suivantes:
(1) l'appareil ne doit pas produire de brouillage, et
(2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi,
même si le brouillage est susceptible d'en compromettre le fonctionnement.
Under Industry Canada regulations, this radio transmitter may only operate
using an antenna of a type and maximum (or lesser) gain approved for the
transmitter by Industry Canada. To reduce potential radio interference to
other users, the antenna type and its gain should be so chosen that the
equivalent isotropically radiated power (e.i.r.p.) is not more than that
necessary for successful communication.
Conformément à la réglementation d'Industrie Canada, le présent émetteur
radio peut fonctionner avec une antenne d'un type et d'un gain maximal (ou
inférieur) approuvé pour l'émetteur par Industrie Canada. Dans le but de
réduire les risques de brouillage radioélectrique à l'intention des autres
utilisateurs, il faut choisir le type d'antenne et son gain de sorte que la
puissance isotrope rayonnée équivalente (p.i.r.e.) ne dépasse pas l'intensité
nécessaire à l'établissement d'une communication satisfaisante.

08 Disposal and Recycling Information
The following symbol signifies that this device has to be disposed
separately from ordinary household wastes at the end of its life.
Please kindly be aware that this is your responsibility to dispose the
electronic device at recycling centers so as to help conserve the natural
resources.
09 Certifications and Safety Approvals
Hereby, Anhui Huami Information Technology Co., Ltd. declares
that the radio device type A2001 is in compliance with Directive
2014/53/EU. The full text of the EU declaration of conformity is
available at the following internet address:
http://en.amazfit.com/support.html

10 Safety Notice
1.
2.
3.
4.
The device is water resistant with a certified rating of 5ATM. This means
that the device is resistant to rain and can be worn while showering. It may
also be used in shallow-water activities, such as swimming in a pool.
However, the watch should not be used when scuba diving, bathing, while in a
sauna, or during other activities involving a high-velocity of water or
submersion below shallow depth.
Please do not operate the watch underwater. After submerging, dry it with a
dry cloth before operating or charging.
The watch is not protected against chemical reagents, acidic or alkaline
solutions, etc. Defects caused by liquid damages are not covered under the
warranty.
11 Warranty and Return Policy
The Amazfit Limited warranty covers Amazfit products against
manufacturing defects beginning on the original purchase date. The
warranty period is 1 year or another period as required to by the applicable
customer laws in the customer’s country of purchase. Our warranty is in
addition to rights provided by applicable customer laws.
Official website: en.amazfit.com
Support website: support.amazfit.com
Importer:
Beryko s.r.o.
Na Roudné 1162/76, 301 00 Plzeň
www.beryko.cz