Amazfit Verge Lite User manual

Amazfit Verge Lite User Manual

1. Amazfit Verge Lite Smartwatch
2. Charging Cradle
3. User Manual
Package Contents
1

Know the Watch
Buon
Watchband
Screen Heart rate sensor
Charging interface
2

Search for "Mi Fit" on the App Store/Google Play or scan the QR code below to download and install
the app.
Install the Mi Fit App on Your Mobile
3

To turn on your watch, press and hold the buon on its top right side. Your watch screen will light up.
To turn off your watch, press and hold the same buon for more than six seconds to display the turn
off interface.
When the screen of the watch is in its resting state aer being switched on, press the same buon as
the above to lighten the screen up shortly.
Turn Your Watch On/Off
4

Open the "Mi Fit" App on your mobile, log in and go to the "Profile" page, select "Add a new device" > "Watch",
then follow the prompts to search and bind it.
Connecting Your Device
5

Aach your watch to the charging cradle as shown in the below. Make sure to alignthefour charging
pins on the backside of the watch with the ones on the charging cradle. Connect the charging cradle
to a USB plug or a computer by using the provided USB cable. The "Charging" notification will display
on the watch screen once it is successfully clipped in. Please use an adapter that is rated 5v and above
1.0A to charge.
Charging Your Watch
6

The watch has the IP68 water and dust resistance rating, which can withstand soaking for 30 minutes
in freshwater at about 1.5 meters deep with normal temperature, but does not support the usage inside
showers, saunas, or swimming pools.
Please do not operate the watch underwater. Aer submerging, dry it with a so cloth before operating
or charging.
The watch is not waterproof against corrosive liquids such as acidic or alkaline solutions, chemical
reagents, etc. The damage or defect caused by misuse or improper use is not within the scope of
warranty.
Safety Notice
1.
2.
3.
7

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
1. This device may not cause harmful interference, and
2. This device must accept any interference received, including interference that may cause undesired
operation.
FCC ID: 2AC8UA1818
Regulatory Notice
8

Note: This product has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This product generates, uses, and can radiate
radio frequency energy and, if not installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no guarantee that interference will
not occur in a particular installation. If this product does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the user is encouraged to
try to correct the interference by one or more of the following measures:
9

- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Please take aention that changes or modification not expressly approved
by the party responsible for compliance could void the user’s authority to
operate the equipment.
10

This device complies with Industry Canada licence-exempt RSS standard(s). Operation is subject to
the following two conditions:
1. This device may not cause interference, and
2. This device must accept any interference, including interference that may cause undesired
operation of the device.
IC: 21806-A1818 CAN ICES-3(B)/NMB-3(B)
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radioexempts
de licence. L'exploitation est autorisée aux deux conditions suivantes :
1. l'appareil ne doit pas produire de brouillage, et
2. l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage.
11

Under Industry Canada regulations, this radio transmier may only operate using an antenna of a type
and maximum (or lesser) gain approved for the transmier by Industry Canada. To reduce potential
radio interference to other users, the antenna type and its gain should be so chosen that the equivalent
isotropically radiated power (e.i.r.p.) is not more than that necessary for successful communication.
Conformément à la réglementation d'Industrie Canada, le présent émeeur radio peut fonctionner
avec une antenne d'un type et d'un gain maximal (ou inférieur) approuvé pour l'émeeur par Industrie
Canada. Dans le but de réduire les risques de brouillage radioélectrique à l'intention des autres
utilisateurs, il faut choisir le type d'antenne et son gain de sorte que la puissance isotrope rayonnée
équivalente (p.i.r.e.) ne dépasse pas l'intensité nécessaire à l'établissement d'une communication
satisfaisante.
12

Disposal and Recycling Information
The use of the WEEE Symbol indicates that the following product may not be treated as a
household waste. By ensuring that this product is disposed correctly, you will help protect the
environment. For a more detailed information about the recycling of the following product,
please contact your local authority, your household waste disposal service provider, or the
shop where you have purchased the product.
Certifications and Safety Approvals
Hereby, Anhui Huami Information Technology Co., Ltd., declares that the radio equipment
type A1818 is in compliance with Directive 2014/53/EU.The full text of the EU declaration of
conformity is available at the following internet address: hp://en.amazfit.com/support.html
13

For more regulatory information and product certification/compliance logos related to Amazfit Verge
Lite, please go to Seings->System->Regulatory on your watch.
14

Name: Amazfit Verge Lite
Model: A1818
Baery Capacity: 390 mAh
Wireless Connectivity: Bluetooth 5.0 BLE
Input Voltage: 5 V DC, 700 mA (Max.)
Frequency: 2402–2480MHz
Max. Output: 0 dBm
Operating Temperatures: 0°C ~ 40°C / 32°F ~ 104°F
Water & Dust Resistance Rating: IP68
Compatible with: Android 4.4, iOS 9.0 or above
Specifications
15

Warranty and Return Policy
All Amazfit products are covered by a 1-year limited warranty. 
Official website: en.amazfit.com
Help: support.amazfit.com 
Email us at: support@amazfit.com
16