Amazon B07SMSB64L User manual

22" Ceramic Tower Heater
Tour de Chauffage en Céramique de 22 po (56 cm)
Calentador de Torre Cerámico de 22 Pulgadas (56 cm)
B07SMSB64L

English . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3
Español . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 12
Français . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 21

3
EN
IMPORTANT INSTRUCTIONS
Read these instructions carefully and retain them for future use.
If this product is passed to a third party, then these instructions
must be included.
When using electrical appliances, basic safety precautions should always
be followed to reduce the risk of fire, electric shock, and/or injury to
persons including the following:
• Read all instructions before using this product.
• This product is hot when in use. To avoid burns, do not let bare
skin touch hot surfaces. If provided, use handles when moving this
product.
• Keep combustible materials such as furniture, pillows, bedding,
papers, clothes and curtains at least 3 feet (0.9 m) from the front of
the product and keep them away from the sides and rear.
• Extreme caution is necessary when the product is used by or near
children, people with reduced physical, sensory or mental capabilities
and whenever the product is left operating and unattended.
• Always unplug the product when not in use.
• Do not operate the product with a damaged cord or plug or after
the product malfunctions, has been dropped or damaged in any
manner. Discard the product or return to authorized service facility for
examination and/or repair.
• Do not use outdoors.
• This product is not intended for use in bathrooms, laundry areas and
similar indoor locations. Never locate the product where it may fall
into a bathtub or other water container.
• Do not run cord under carpeting. Do not cover cord with throw rugs,
runners or similar coverings. Do not route cord under furniture or
appliances. Arrange cord away from traffic area and where it will not
be tripped over.
• To disconnect the product, turn controls to off, then remove plug
from outlet.
• Do not insert or allow foreign objects to enter any ventilation or
exhaust opening as this may cause an electric shock or fire, or
damage the product.

4
EN
• To prevent a possible fire, do not block air intakes or exhaust in any
manner. Do not use on soft surfaces, like a bed, where openings may
become blocked.
• A heater has hot and arcing or sparking parts inside. Do not use it in
areas where gasoline, paint or flammable liquids are used or stored.
• Use this product only as described in this manual. Any other use not
recommended by the manufacturer may cause fire, electric shock or
injury to persons.
• Always plug the product directly into a wall outlet/receptacle. Never
use with an extension cord or relocatable power tap (outlet/power
strip).
• This appliance has a polarized plug (one blade is wider than the
other). To reduce the risk of electric shock, this plug will fit the outlet
only one way. If the plug does not fit fully in the outlet, reverse the
plug. If it still does not fit, contact a qualified electrician. Do not modify
the plug in any way.
• A heater may include an audible (a visual) alarm to warn that parts of
the heater are getting excessively hot. If the alarm sounds (flashes),
immediately turn the heater off and inspect for any objects on or
adjacent to the heater that may cause high temperatures. DO NOT
OPERATE THE HEATER WITH THE ALARM SOUNDING (FLASHING).
• Place the product on a flat and stable surface to avoid risk of tipping
it over.
• This product draws up to 1500 W of power. To prevent overloading of
the electrical circuit, do not plug the product into a circuit with other
appliances already connected.
• This appliance has a polarized plug (one blade is wider than the
other). To reduce the risk of electric shock, this plug will fit outlet only
one way. If the plug does not fit fully in the outlet, reverse the plug. If it
still does not fit, contact a qualified electrician. Do not modify the plug
in any way.
SAVE THESE INSTRUCTIONS
Battery warnings
• Always insert batteries correctly with regard to polarity (+ and –)
marked on the battery and the product.
• Exhausted batteries should be immediately removed from product
and properly disposed.

5
EN
Intended Use
• This product is intended for temporarily heating residential rooms with
an effective area coverage of 120-160 ft2(11-15 m2).
• This product is intended for household use only. It is not intended for
commercial use.
• This product is intended to be used in dry indoor areas only.
• No liability will be accepted for damages resulting from improper use
or non-compliance with these instructions.
Before First Use
• Check the product for transport damages.
• Before connecting the product to the power supply, check that the
power supply voltage and current rating corresponds with the power
supply details shown on the product rating label.
DANGER Risk of suffocation! Keep any packaging materials away
from children – these materials are a potential source of danger, e.g.
suffocation.
Inserting the batteries
• Open the battery compartment located in the back of the remote
control (M).
• Insert two LR03/AAA 1.5 V batteries (not provided). Always insert
batteries correctly with regard to polarity (+ and –) marked on the
battery and the product.
• Close the battery compartment.
NOTICE Replace the batteries if the range of the remote control
decreases noticeably or if the product cannot be controlled via remote
control.

6
EN
Product description
A
L
C
D
F
EGH
I
J
M
G
F
HE
I
K
B
N
J
APower cord with power plug HSwing button
BBase notches IIncrease value button
CFront grill JDecrease value button
DControl panel KDisplay
EPower button LAir filter
FMode button MRemote control
GTimer button NCarrying handle

7
EN
Operation
Positioning the product
• The product can be placed in a vertical or horizontal position.
• Place the product on a flat and stable surface to avoid risk of tipping
it over.
CAUTION Risk of fire! In case of choosing the horizontal position,
place the product on the side with the base notches (B).
B
Switching on/off
• Connect the power plug (A) to the suitable outlet. The product beeps
and the power indicator lights up on the display (K).
• To switch on, press the power button (E). The current temperature
and mode indicators light up on the display (K).
• To switch off, press the power button (E) again. The product switches
off after 15 seconds of cooling down. The current temperature and
mode indicators go off.
NOTICE If no button is pressed for 60 seconds, the temperature
indicator goes off.
NOTICE After switching off, the product starts operation with the
last set temperature, mode and swing setting.

8
EN
Setting the mode
Press the mode button (F) repeatedly to toggle between the modes:
Symbol Mode Description
High speed The product operates at high speed.
Low speed The product operates at low speed.
Fan Fan only, no heating.
ECO mode
The product adjusts the mode
automatically according to the set
temperature to optimize energy
consumption.
Setting the temperature
• Press the increase (I) or decrease button (J). The temperature
indicator starts flashing.
• To set the temperature keep pressing the increase (I) or decrease
button (J). The product beeps after 5 seconds and the temperature
is set.
• When the room reaches the set temperature, its indicator flashes for
10 seconds and goes off. The product enters the standby mode.
• When the room temperature decreases, the product switches on
again automatically.
NOTICE You can also press and hold the increase (I) or decrease
button (J) to quickly set the temperature. The temperature can be set
between 40-95 °F (4.5-35 °C).
Setting the timer (automatic switch off)
• Press the timer button (G). The hstarts flashing.
• Keep pressing the increase (I) or decrease button (J) to set the timer.
• Press the timer button (G) again, or wait 5 seconds. The set time
stops flashing. The timer indicator lights up.
• The product switches off automatically after the set time.

9
EN
Setting the timer (automatic switch on)
• When the product is switched off, press the timer button (G). The h
starts flashing.
• Keep pressing the increase (I) or decrease button (J) to set the timer.
• Press the timer button again, or wait 5 seconds. The set time stops
flashing. The product beeps. The timer indicator and the timer
setting light up.
• The product switches on automatically after the set time.
Swing function
• To switch on the swing function, press the swing button (H). The
swing indicator lights up.
• To switch off the swing function, press the swing button (H) again.
The swing indicator goes off.
Temperature indicator automatic switch off
The product features the temperature indicator automatic switch off
function. If no button is pressed for 60 seconds, the temperature
indicator goes off.
• To switch off the function, press and hold the increase (I) and
decrease buttons (J) for two seconds. The product beeps twice. The
temperature indicator is constantly on.
• To switch the function back on, press and hold the increase (I) and
decrease buttons (J) again. The product beeps twice.
Cleaning and Maintenance
WARNING Risk of electric shock! To prevent electric shock,
unplug the product before cleaning.
WARNING Risk of electric shock! During cleaning do not
immerse the product in water or other liquids. Never hold the product
under running water.
Cleaning the product
• To clean the product, wipe with a soft, slightly moist cloth.
• Dry the product after cleaning.
• Never use corrosive detergents, wire brushes, abrasive scourers,
metal or sharp utensils to clean the product.

10
EN
Cleaning the filter
• Press down both latches to open the cover of the air filter (L).
Remove the filter.
• Tap on the filter to remove the dirt.
• If the filter is heavily soiled, rinse it with warm water and let it dry.
• Reinsert the filter and the cover.
Storage
• Store the product in a dry, safe place away from children.
Troubleshooting
Problem Solution
The product does not switch
on.
• Check if the plug is connected
to the outlet. Check if the outlet
works.
The product does not heat. • The set temperature is lower
than current room temperature.
Set a higher temperature.
The product suddenly stops
operation and flashes on
display. The buttons do not
work.
• The product has overheated.
The overheating protection has
been activated. Unplug the
product and let is cool for at
least 10 minutes.
The product suddenly stops
operation and or flashes
on display. The buttons do not
work and alarm rings 10 times.
Short-circuit in the temperature
sensor.
• Do not try to repair the product
yourself. Consult a qualified
electrician.
Bad smell. • It is the result of dust or other
debris accumulating on the
heating element. This is normal
during first use and after
prolonged storage. Place the
product in a well ventilated area.
Keep the product switched on,
until the smell disappears.

11
EN
Specifications
Rated voltage: 120V~, 60Hz
Power consumption: 900 W (low speed)
1500W (high speed)
Current consumption: 12.5A
Area coverage: 120-160 ft2(11-15 m2)
Battery type: 2 x LR03/AAA 1.5 V
Protection class: Class II
Net weight: 6.2 lbs (2.8 kg)
Dimensions (W x H x D): 6.3 x 21.7 x 6.8"
(16 x 55.1 x 17.4cm)
Feedback and Help
Love it? Hate it? Let us know with a customer review.
AmazonBasics is committed to delivering customer-driven products
that live up to your high standards. We encourage you to write a review
sharing your experiences with the product.
amazon.com/review/review‑your‑purchases#
amazon.com/gp/help/customer/contact‑us

amazon.com/AmazonBasics
V05-08/19
MADE IN CHINA
HECHO EN CHINA
FABRIQUÉ EN CHINE