Ambient Weather WS-152T User manual

Version 1.0 ©Copyright 2014, Ambient LLC. All Rights Reserved. Page 1
Ambient Weather WS-152T 6" Contemporary
Thermometer User Manual
Table of Contents
1. Introduction.....................................................................................................................................2
2. Care and Cleaning...........................................................................................................................2
3. Dial Thermometer...........................................................................................................................2
4. Installation.......................................................................................................................................2
5. Measurement Specifications ...........................................................................................................2
6. Warranty Information......................................................................................................................2

Version 1.0 ©Copyright 2014, Ambient LLC. All Rights Reserved. Page 2
1. Introduction
Thank you for your purchase of the Ambient Weather WS-152T 6" Contemporary Thermometer. The
following is a guide for preparation, care and operation of your traditional weather station.
2. Care and Cleaning
Avoid use of harsh household cleaners and coarse paper towels, which can damage the lacquer coating
or scratch the bezel or lens. Fingerprints and dirt may be removed the lenses and bezels with a soft
cloth lightly dampened with a mixture of water and mild dishwashing liquid. Be sure to dry the lens
and bezel with a soft cloth after cleaning.
Do not install the weather station outside. The weather station is intended for indoor use only.
3. Dial Thermometer
The dial thermometer uses a bimetallic strip wrapped into a coil. One end of the coil is fixed to the
housing of the device and the other drives an indicating needle. The principle behind a bimetallic strip
thermometer relies on the fact that different metals expand at different rates as they warm up.By
bonding two different metals together, the coil bends, causing the needle to move. Bimetallic
thermometers are not as accurate as bulb (mercury or red spirit) thermometers.
4. Installation
To install the traditional weather station, hang the case on a wall with the hole built into the case. Only
install indoors, in a clean area.
5. Measurement Specifications
The following table provides specifications for the measured parameters.
Measurement
Range
Accuracy
Resolution
Indoor Temperature
-30 to 150 °F
± 3.6 °F
2 °F
6. Warranty Information
Ambient, LLC provides a 1-year limited warranty on this product against manufacturing defects in
materials and workmanship.
This limited warranty begins on the original date of purchase, is valid only on products purchased and
only to the original purchaser of this product. To receive warranty service, the purchaser must contact
Ambient, LLC for problem determination and service procedures.
Warranty service can only be performed by a Ambient, LLC. The original dated bill of sale must be
presented upon request as proof of purchase toAmbient, LLC.
Your Ambient, LLC warranty covers all defects in material and workmanship with the following
specified exceptions: (1) damage caused by accident, unreasonable use or neglect (lack of reasonable
and necessary maintenance); (2) damage resulting from failure to follow instructions contained in your
owner’s manual; (3) damage resulting from the performance of repairs or alterations by someone other

Version 1.0 ©Copyright 2014, Ambient LLC. All Rights Reserved. Page 3
than an authorized Ambient, LLC authorized service center; (4) units used for other than home use (5)
applications and uses that this product was not intended, such as outdoor use.
This warranty covers only actual defects within the product itself, and does not cover the cost of
installation or removal from a fixed installation, normal set-up or adjustments, claims based on
misrepresentation by the seller or performance variations resulting from installation-related
circumstances.