American Standard Bordeaux Vanity and Mirror 9586.101 User manual

I1
© 2008 AS America Inc. Revised 2/08
BORDEAUX™
VANITY and MIRROR
WOOD
BORDEAUX™ VANITY
❏ 9532.200 Bordeaux Vanity
• Made from Alder solids with Cherry veneers
• European French Country bow front chest
vanity with matching wood top
• Optional Marble top pre-cut for Ovalyn
undercounter drilled with 8" faucet holes
• Aged Chestnut with a hand-distressed nished
and antiqued brass hardware in bronze
• Features curved interior adjustable shelves
• Right Height™ for greater comfort during use
Nominal Dimensions:
32-3/8" x 21-1/4" (822 x 540mm)
35-5/8" (905mm) height (w/Wood top)
35-3/4" (908mm) height (w/Marble top)
❏ 9586.101 Bordeaux Mirror
• Solid Alder wood frame and mirror compliments
Bordeaux Vanity
Nominal Dimensions:
26-1/8" x 38-1/4"
(664 x 972mm)
SEE REVERSE SIDE FOR ROUGHING-IN DIMENSIONS
To Be Specied (Recommended Sinks for Wood Top):
❏ 0575.000 Coventry
❏ 0573.000 Sebring
To Be Specied (Optional):
❏ 9532.495 Marble top pre-cut for Ovalyn
undercounter drilled with 8" faucet holes
❏ 0495.221 Ovalyn undercounter sink required for
Marble top (specify color)
❏ Faucet*: Variety of American Standard faucets are
available (specify nish)
*See faucet section for available models
NOTE: The above are photographs of the Bordeaux Marble
Vanity Top and are to be only used as a guide for selection.
Marble is a natural product and as such may vary in shading
and texture. Viewing Marble Tops on display at a local
American Standard Dealer is recommended.
River Sand
9532.200 Bordeaux Vanity shown with optional River
Sand Marble top, Ovalyn undercounter and Amarilis
Jasmine faucet with metal lever handle.
9586.101 Bordeaux Mirror.

I2
© 2008 AS America Inc.
BORDEAUX™
VANITY and MIRROR
WOOD
9532.200 Bordeaux Vanity with Wood Top 9586.101 Bordeaux Mirror.
32-3/8"
(822mm)
A
32-3/4"
(832mm)
*22-3/4"
(578mm)
*24-3/4"
(629mm)
FINISHED FLOOR
6"
(152mm)
4"
(102mm)
TYP ANCHORING HOLES
21-1/4"
(540mm)
A= 35-5/8"(981mm)
with Wood top
A= 35-3/4"(908mm)
with Marble top Option
6" (152mm)
1-1/4" O.D.
WASTE SUPPLIES
AS REQ'D
1-7/8"
(48mm)
26-1/8"
(664mm)
38-1/4"
(972mm)
NOTES:
* DIMENSIONS SHOWN FOR LOCATION OF SUPPLIES AND “P”
TRAP ARE SUGGESTED.
- FITTINGS NOT INCLUDED AND MUST BE ORDERED SEPARATELY.
PROVIDE SUITABLE REINFORCEMENT FOR ALL WALL SUPPORTS.
IMPORTANT: Dimensions of xtures are nominal and may vary within
the range of tolerances established by ANSI Standard A112.19.2.
These measurements are subject to change or cancellation. No
responsibility is assumed for use of superseded or voided pages.
Revised 2/08