American Standard Generations 30" Vanity 9210.030.329 Instruction manual

ASSEMBLY & INSTALLATION INSTRUCTIONS
- 1 -
Recommended Tools & Materials
Roughing-in
Dimensions
Product names listed herein are trademarks of AS America, Inc.
© AS America, Inc. 2008
Hacksaw
Channel Locks
Adjustable Wrench
Tubing Cutter
Basin Wrench
Putty Knife
Tape
Measure
Plumbers’ Putty or
Caulking
Regular Screwdriver
Phillips Screwdriver
Drill
Level
Pipe Wrench
Generations 30" Vanity
9210.030.329
To maintain the beauty of the finish, avoid placing the furniture in direct sunlight, as sunlight causes fading. Also avoid
extreme changes in temperature by arranging furniture away from radiators, heat and air vents, and air conditioning
units. Avoid placing furniture directly under windows.
30"
(762mm) 21-1/2"
(546mm)
33-1/2"
(851mm)
27-1/4"
(692mm)
4-3/4"
(120mm)
20"
(508mm)
22"
(559mm)
NEWBERN SINK
8"
(203mm)
FINISHED
FLOOR
FINISHED
FLOOR
FINISHED
WALL
VANITY TOP
9210.130.251 Laminated 31" Marble Top
No additional top required for Newbern
Vanity Top
0615.000 Rattan Undermount Sink
7820.400.020 Newbern Vanity Top
-4" Centers
7820.800.020 Newbern Vanity Top
-8" Centers
7005.201 Copeland
Center Set Faucet
7005.801 Copeland
Widespread Faucet
RECOMMENDED SINKS RECOMMENDED FAUCETS
770011-100
1-1/4" (32mm)
O.D. WASTE
OPTIONAL:
LAMINATED MARBLE
TOP WITH RATTAN
UNDERMOUNT SINK
SUPPLIES AS
REQUIRED
Thank you for selecting our products...products which have been the benchmarks of fine quality for over 100 years. To
help insure that the installation process will proceed smoothly, please read these instructions carefully before you begin.
Also, review the recommended tools and materials list; carefully unpack and examine your new plumbing fixture.

- 2 -
VANITY INSTALLATION
Unpack unit carefully, taking care that bottom shelf does not drop and damage front legs (see Figure 2).
Provide suitable reinforcement for anchoring the vanity to the wall. Centerline of reinforcement should be 31" up
from the floor (see Figure 1).
Rough in supply lines and waste per rough-in dimensions.
The molding needs to be notched to seat the vanity flush against the wall.
Move the vanity into place and level with the adjustable glides on the bottom of the feet.
The glides can be adjusted outward up to 1" but it is recommended not to exceed 1/2" if possible.
Drill at least two 3/8" O.D. anchoring holes through the centerline of the rear stringer of the vessel stand, located 1"
down from the top of the table (see Figure 2).
Anchor the vanity to the wall through at least 2 of the anchoring holes in the rear of the vanity (see Figure 2).
Continue with installation appropriate for top and sink options chosen.
C/L of 2 x 6
Reinforcement
Finished
Floor
31"
(787mm)
FIGURE 1
ADJUSTABLE
LEVELLERS
(under each
foot)
ANCHORING HOLES
IN REAR STRINGER
[NOT SHOWN]
3"
(76mm)
REAR STRINGER WITH
ANCHORING HOLES TO
SECURE VANITY TO WALL
FIGURE 2
770011-100
21-1/2"
(546mm)
33-1/2"
(850mm)

770011-100
- 3 -
Turn the marble top upside down and place it on a clean, scratch
resistant surface. Apply a bead of silicone adhesive to the rim of
the sink. Center the sink over the cutout and (secure it to the top
using the mounting kit provided).
NOTE:
Use the 4 brackets supplied with the sink mounting kit
and the 4 screws supplied with the marble top to secure the sink to
the underside of the marble top.
Turn the top right-side up and install the faucet per the manufacturer’s instructions.
Apply a bead of silicone adhesive to the rim of the vanity. Place the marble top
centered left to right on the vanity and with the back edge of the top even with the
rear of the vanity. Clean up any excess silicone.
Connect the trap to the drain assembly hand tight to check alignment. It may be
necessary to cut off part of the tailpiece (area "A") or part horizontal leg of the
trap (area "B").
Connect hot and cold supply lines to the shut off valves. Tighten trap joints for
watertight assembly.
NOTE: Marble top comes pre-cut for the Rattan Undercounter sink and 8"
faucet spread. Also it is strongly recommended that the marble top be sealed after
installation and prior to use.
Mount the drain assembly (not included) on the sink. Be certain to apply a bead of
sealing putty on the underside of the drain (Part "A") in order to ensure a watertight seal
between the sink and drain. Remove excess putty after installing the drain on the sink.
MARBLE TOP 9210.130.251 WITH RATTAN 0615 UNDERCOUNTER SINK
NEWBERN VANITY SINK 7820.400 AND 7820.800
INSTALLATION onto VANITY
Two people recommended for this installation
A
B
Two people recommended for this installation
A
Mount the drain assembly (not included) on the sink. Be certain to apply
a bead of sealing putty on the underside of the drain (Part "A") in order to ensure
a watertight seal between the sink and drain. Remove excess putty after installing
the drain on the sink.
Apply a bead of silicone adhesive to the rim of the vanity. Place the top centered
left to right on the vanity and with the back edge of the top even with the rear of
the vanity. Apply a bead of silicone along the top back edge of the vanity top
and the wall. Clean up any excess silicone.
Connect the trap to the drain assembly hand tight to check alignment. It may be necessary
to cut off part of the tailpiece (area "B") or part horizontal leg of the trap (area "C").
Connect hot and cold supply lines to the shut off valves.
Tighten trap joints for watertight assembly.
A
B
C

-4-
REPLACEMENT PARTS LIST
9210.030.329 Generations 30" Vanity
Care and Cleaning of Vanity
Clean the product by using soft, slightly damp cloth. Buff the product by using a soft dry cloth. Avoid using silicone cleaners and waxes.
Clean up excess water and spills immediately. Use a blotting rather than a wiping action. Water left over a long period of time will cause white
spots in the finish.
NOTE: Please note that some chemicals may damage the finish. Take care to avoid the following: iodine, hair dye, after shave lotion, shaving
cream, alcohol, perfume, Lestoil®, Lysol Tub and Tile Cleaner®, Lysol Spray Disinfectant®, Dow Disinfectant®, acetone, paint remover, Formula
409®, Tile-X®, and Nair®.
Care and Cleaning of the Marble Vanity Top
Marble is porous and easily stained. Wipe off anything spilled on it immediately. It should be washed or cleaned regularly with fresh warm water
and a non-abrasive clean cloth. Also, using a non-abrasive, neutral (pH balanced) cleaner will help remove dirt and grime, but it is recommended to
first try warm water only.
Marble should be sealed regularly with a good quality marble sealer. Marble sealers are available at most retail home supply stores. Follow the
instructions on the sealer container for proper application and frequency of use. The sealer acts as a stain inhibitor and prevents most stains and
soil from being absorbed into the porous surface, but it is NOT a guarantee against staining. All spills should be cleaned immediately. Avoid
contact with all oils and petroleum-based products. Also, avoid contact with all acid or caustic products such as vinegar, citrus or fruit juices, soda,
chlorine, and nail polish remover. If the marble is well sealed, the warm water and non-abrasive cloth should keep it clean.
Child Pull-Out Step
[Shown Closed]
Child Pull-Out Step
Door opens
to access
Storage
Laminated Marble Top
and Rattan
Undercounter Sink Newbern
Vanity Sink
770011-100
REPAIR PART NO. DESCRIPTION
THREADER LEVELLER (1 PER PACK) FOR VANITY / STEP
DOOR PULL - GENERATIONS 30" VANITY
SHELF CLIPS FOR ADJUSTABLE SHELF
730679-0070A
770007-0070A
770009-0070A
VANITY TOP
9210.130.251 Laminated 31" Marble Top
No additional top required for Newbern
Vanity Top
0615.000 Rattan Undermount Sink
7820.400.020 Newbern Vanity Top
-4" Centers
7820.800.020 Newbern Vanity Top
-8" Centers
7005.201 Copeland
Center Set Faucet
7005.801 Copeland
Widespread Faucet
RECOMMENDED SINKS RECOMMENDED FAUCETS

In the United States:
American Standard Inc.
P.O. Box 6820
Piscataway, New Jersey 08855
Attention: Director of Consumer Affairs
For residents of the United States, warranty information
may also be obtained by calling the following
toll free number: [phone]
www.americanstandard-us.com
In Canada:
American Standard
2480 Stanfield Rd.
Mississauga, Ontario
Canada L4Y 1S2
Toll Free: [phone]
www.americanstandard.ca
In Mexico:
Customer Service Manager
Ideal Standard, S.A. de C.V.
Via Morelos #330
Col. Santa Clara
Ecatepec 55540 Edo. Mexico
www.americanstandard.com.mx
- 5 -
AS AMERICA, INC. (“AMERICAN STANDARD”) WOOD FURNITURE WARRANTY
If inspection of this AS America, Inc. (“American Standard”) plumbing product, within one year after its initial purchase, confirms that
it is defective in materials or workmanship, American Standard will repair or, at its option, exchange the product for a similar model.
Variations in actual wood color and finishes which may result from natural characteristics of the wood, such as grain patterns,
mineral streaks and the like, are not defects and are not covered by this warranty.
This warranty applies only to the original purchaser and installation of these products.
This limited warranty does not apply to local building code compliance. Since local building codes vary considerably, the purchaser
of this product should check with a local building or plumbing contractor to insure local code compliance before installation.
This warranty shall be void if the product has been moved from its initial place of installation; if it has been subjected to faulty
maintenance, abuse, misuse, accident or other damages; if it was not installed in accordance with American Standard’s
instructions; or if it has been modified in a manner inconsistent with the product as shipped by American Standard.
American Standard’s option to repair or exchange the product under this warranty does not cover any labor or other costs of
removal or installation, nor shall American Standard be responsible for any other incidental or consequential damages attributable
to a product defect or to the repair or exchange of a defective product, all of which are expressly excluded from this warranty.
(Some states or provinces do not allow the exclusion or limitation of implied warranties, so this exclusion may not apply to you).
This warranty gives you specific legal rights. You may have other statutory rights that vary from state to state or province to
province, in which case this warranty does not affect such statutory rights.
AS AMERICA, INC. (“AMERICAN STANDARD”) MARBLE / GRANITE VANITY/TABLE TOP LIMITED WARRANTY
If inspection of this AS America, Inc. (“American Standard”) plumbing product, within one year after its initial purchase, confirms that
it is defective in materials or workmanship, American Standard will repair or, at its option, exchange the product for a similar model.
Variations in shading, veining, and texture which may result from natural characteristics of stone and as such are not defects and
are not covered by this limited warranty.
This limited warranty applies only to the original purchaser and installation of these products. In the event of a claim, proof of
purchase will be required; save your receipt.
This limited warranty does not apply to local building code compliance. Since local building codes vary considerably, the purchaser
of this product should check with a local building or plumbing contractor to insure local code compliance before installation.
This limited warranty is void if the product has been moved from its initial place of installation; if it has been subjected to faulty
maintenance, abuse, misuse, accident or other damages; if it was not installed in accordance with American Standard’s
instructions; or if it has been modified in a manner inconsistent with the product as shipped by American Standard.
American Standard’s option to repair or exchange the product under this limited warranty does not cover any labor or other costs of
removal or installation, nor shall American Standard be responsible for any other incidental or consequential damages attributable
to a product defect or to the repair or exchange of a defective product, all of which are expressly excluded from this limited
warranty. This limited warranty does not cover any liability for consequential or incidental damages, all of which are hereby
expressly disclaimed, or the extension beyond the duration of this limited warranty of any implied limited warranties, including those
of merchantability or fitness for an intended purpose. (Some states or provinces do not allow the exclusion or limitation of implied
limited warranties, so this exclusion may not apply to you).
This limited warranty gives you specific legal rights. You may have other statutory rights that vary from state to state or province to
province, in which case this limited warranty does not affect such statutory rights.
For service under these limited warranties, it is suggested that a claim be made through the contractor or dealer from or through
whom the product was purchased, or that a service request (including a description of the product model and of the defect) be sent
to the following address:
770011-100