American Standard Colony FitRight Right Height Elongated 12" Rough-In Toilet... User manual


© 2008 AS America Inc.
COLONY™ FitRight™ RIGHT HEIGHT™
ELONGATED 12" ROUGH-IN TOILET
VITREOUS CHINA
COLONY™ FitRight™ RIGHT HEIGHT™
ELONGATED 12" ROUGH-IN TOILET
❑ 2437.012
• Vitreous china
• Low-consumption (6.0 Lpf/.6 gpf)
• 6-/2" rim height for accessible applications
• Elongated siphon action jetted bowl
• Pilot valve water control
• Fully glazed 2" trapway
• 2" Flapper ush valve
• Color-matched trip lever
• Sanitary bar on bowl
• 2 bolt caps
• 00% factory ush tested
❑ 3191.016 Bowl
❑ 4003.016 Tank
Nominal Dimensions:
724 x 457 x 778mm
(28-/2" x 8" x 30-5/8")
Fixture only, seat and supply by others
Alternate Tank Congurations Available:
❑ 4003.500 Tank complete with Aquaguard Liner
❑ 4003.800 Tank complete with trip lever located
on right side
Compliance Certications -
Meets or Exceeds the Following Specications:
• ASME A2.9.2M for Vitreous China Fixtures -
includes Flush Performance, Ball Pass Diameter,
Trap Seal Depth and all Dimensions
• Los Angeles Department of Water and Power
Supplementary Purchase Specication for
Non-Adjustability

NN

NN

NN

NN

NN

NN

NN

NN

NN

NN

NNNN

NN
'*/*4)&%
8"--
'*/*4)&%
'-003
4611-:
"4
3&2h%
NN

$-0'4&"51045)0-&4
NN$&/5&34
NN

$-0'065-&5
NN
 
NN
To Be Specied:
❏ Color: ❏ White:
❏ Seat: American Standard #5324.09 “Rise and
Shine" solid plastic closed front seat with cover.
❏ Seat: American Standard #53.02 “Laurel"
molded closed front seat with cover.
❏ Alternate Seat:
❏ Supply with stop:
NOTES:
THIS COMBINATION IS DESIGNED TO ROUGH-IN AT A MINIMUM DIMENSION
OF 305MM (2") FROM FINISHED WALL TO C/L OF OUTLET.
* DIMENSION SHOWN FOR LOCATION OF SUPPLY IS SUGGESTED.
SUPPLY NOT INCLUDED WITH FIXTURE AND MUST BE ORDERED
SEPARATELY.
IMPORTANT: Dimensions of xtures are nominal and may vary within the range
of tolerance established by ANSI Standard A2.9.2
These measurements are subject to change or cancellation. No responsibility is
assumed for use of superseded or voided pages.
MEETS THE AMERICANS WITH DISABILITIES ACT GUIDELINES AND
ANSI A117.1 REQUIREMENTS FOR ACCESSIBLE AND USABLE
BUILDING FACILITIES-CHECK LOCAL CODES.
08/08