American Standard Culinaire 4147.100 User manual

SINGLE CONTROL KITCHEN
FAUCET AND PULL OUT SPRAY
Installation
Instructions
.3&7
Certified to comply with ANSI A112.18.1M
4147.100
Culinaire

1
2
4
5
6
7
8
9
CAUTION
INSTALL FITTING WITH OR WITHOUT DECK ESCUTCHEON
Turn off hot and cold water
supplies before beginning.
PUTTY
Plumbers' Putty or Caulking
Adjustable Wrench
Phillips Screwdriver
Channel Locks
TOOLS REQUIRED
Insert supply HOSES (3) and SHANK (4) through center hole of ESCUTCHEON (1)
(if used) sink or mounting surface.
Make certain the large SEAL (2) is properly seated in recess of faucet body.
Use a screwdriver to tighten the SCREWS (9) on LOCKNUT (7). Work your way
around LOCKNUT (7), tightening the screws slightly each time until all are snug to
ensure even pressure.
3
Apply a bead of putty to bottom edge of ESCUTCHEON (1).Note: Installation of
ESCUTCHEON (1) is optional.
Assemble RUBBER WASHER (5), BRASS WASHER (6), and threaded LOCKNUT (7)
onto SHANK (4) from underside of sink. Hand tighten LOCKNUT (7) and check that
faucet is centered. NOTE: FAUCET CAN BE INSTALLED FOR RIGHT OR LEFT HAND APPLICATIONS.
LH RH
5VCJOH$VUUFS
Congratulations on purchasing your American Standard faucet with
EverClean nish found only on American Standard faucets.
EverClean Finish
• One wipe eortlessly removes spots
• Eliminates the need for cleaners and scrubbing
• Permanent surface protectant remains beautiful for the life of the faucet
• EverClean™ available on: Polished Chrome, Satin Nickel, Stainless Steel, Polished Brass (or any combination of these nishes)
To ensure that your installation proceeds smoothly-please read these instructions carefully before you begin.
with EverClean™ Finish

.3&7
RED
STRIPE
BLUE
STRIPE
MAKE WATER SUPPLY CONNECTIONS
Turn off hot and cold water supplies before beginning.
Connect FLEXIBLE SUPPLIES (1, 2) directly to wall supplies. Connection
on fitting supplies are 3/8" compression. Connect left supply
(Marked with a Red Stripe) to Hot and right supply (Marked with
Blue Stripe) to Cold wall supply. Use adjustable wrench to
tighten connections. Do not over tighten.
Faucet supplies are 24" long from
faucet base.
Note: If additional supply length
is required, installer must
purchase additional parts
separately.
Important: If SUPPLY HOSES
(1, 2) are too long, loop as
illustrated to avoid kinking.
1
2
COLD
HOT
CONNECT HOSE SPRAY
and INSTALL WEIGHT
Figure 2
Figure 1
Tighten COUPLING NUT (2) to
SPRAY HOSE (1).Figure 1
Install WEIGHT (4) onto HOSE (3)
using two screws (5). locate
WEIGHT (4) two feet from
underside of mounting surface.
Figure 2
Tighten SCREWS (5) firmly.
1
3
HOT AND
COLD SUPPLIES
UNDER SIDE
OF MOUNTING
SURFACE
2
4
5
24"

.3&7
American Standard’s EverClean finish will wipe clean with a soft, dry cloth. A soft cloth with clean
water may also be used, if desired. No additional cleaning products are required.
DO NOT USE: Soaps, acid, polish, abrasives, harsh cleaners, or a cloth with a coarse surface.
EverClean™ Finish Care Instructions
TEST INSTALLED FAUCET
Move HANDLE (1) into "off" position and remove AERATOR (2).
Turn on water supplies and check connections for leaks.
Operate HANDLE (1) on and off, hot and cold to flush water lines
thoroughly.
Pull SPRAY (3) out and activate. Check hose and supply connections for leaks.
Move HANDLE (1) to "off" position and replace SPRAY (3) and AERATOR (2).
2
1
3
CHECK FOR LEAKS
Remove BUTTON (1) and loosen HANDLE
SCREW (1) with 2mm Hex Wrench then pull off
HANDLE (2).
Unscrew ESCUTCHEON CAP (3). Unscrew the
CARTRIDGE NUT (4).
Remove CARTRIDGE (5). Clean inlets of CARTRIDGE (5)
and MANIFOLD (6).
Reassemble CARTRIDGE (5). Replace CARTRIDGE NUT (4),
CAP (3) and HANDLE (6) assembly, check flow.
SERVICE
Clogged CARTRIDGE outlets or inlets may cause reduced
flow. To clean, first turn off water supply then:
Reduced flow. If the flow should gradually be reduced over a number of months,
the AERATOR may have debris in it. To clean, remove AERATOR (7) and rinse with
water to remove any debris. Turn on faucet to wash any debris out of the faucet.
Screw AERATOR (7) back into the spout. Operate faucet.

7
5
6
1
3
4
2
