American Standard Heritage Bidet 5034 User manual

Installation
Instructions
730286-100 (Rev. A)
MODEL 5032/5034
Thank you for selecting American-Standard...the benchmark
of fine quality for over 100 years.
To ensure that your installation proceeds smoothly--please
read these instructions carefully before you begin.
Certified to comply with ANSI A112.19.2M
Observe local plumbi g a d buildi g codes.
HERITAGE BIDET
INSTALLATION
Refer to bidet illustratio s. Measure the dista ce
from the fi ished wall to the ce ter of the drai outlet
correspo di g to selected bidet model dime sio .
Check that the dista ce betwee the fi ished wall to
the e d of the bidet is compatible with cleara ce
requireme ts of your bidet fitti g.
Provisio s must be made for the i stallatio of a
"P" trap i the floor whe drai outlet is i stalled.
Water supplies should be located ear the
ce ter li e of the bidet, approximately 4 i ches
(102mm) to either side. Wall supply i stallatio s
must be approximately 6 i ches (152mm) above
the floor a d protrude a mi imum of 3-1/4 i ches
(83mm) from the wall. Complete rough-i usi g
a gle 3/8" (10mm) stop valves. If floor supply
i stallatio is desired, check dime sio s from fi ished
wall to e d of the bidet a d rough-i appropriately.
Use straight stop valves.
A clip is provided to secure the fro t foot of the bidet.
Locate the holes of the clip (raised sectio poi ts away
from the wall) 11" (279mm) from the ce ter of the
drai outlet alo g the ce ter li e of the bidet. Use 1"
wood screws ( ot provided) to secure clip to floor.
It is recomme ded that you i stall the bidet fitti g a d
drai assembly at this time to ease i stallatio .
Secure rear bidet to floor usi g headless ha ger
screws supplied.
ROUGHING-IN 1.
Product ames listed herei are trademarks of America Sta dard I c.
America Sta dard I c. 1994
C
HOTLINE FOR HELP
For toll-free i formatio a d a swers to your questio s, call:
1 [phone],
Weekdays 8:00 a.m. to 4:00 p.m. Easter Time
If a side by side toilet a d bidet i stallatio is
desired, a comfortable separatio of 2 feet
(610 mm) is required betwee the u its.
2.
3.
4.
5.
FINISHED WALL
13-1/4"
(337mm)
3-3/4"
(95mm)
WALL
SUPPLY
HEADLESS
ANCHOR
SCREW
FLOOR
SUPPLY
DRAIN OUTLET
11"
(279mm)
CLIP
FINISHED
FLOOR
WOOD
SCREWS
5"
(127mm)