American Standard Neo Modern Installation instructions

Rev. A1 - 1 -
- 4 -
FFAS0711-601500BF0
Single Lever Exposed B&S Faucet
1
2
3
4
5
6
FFAS0712-701500BF0
Single Lever Exposed Shower Only
FFAS0711-601500BF0 FFAS0712-701500BF0
Cold
O N
Hot
Cold
O N
H o t
135~165
117
159
44 21
20
70
G1/2
G1/2
42
220
80
31
64.7
21
36
140.5
70
G1/2
42
135~165
G1/2
6.5
220
80
31
AB
Neo Modern
Neo Modern
1
2
Test / Usage
* Move handle down into “OFF”position. Turn on supply angle valve to check all connections for leak.
* Operate handle up and down, left and right to flush water lines thoroughly.
Test
Usage
Trouble Shooting Guide
Untwist the hose.
Cartridge packing
Hose junction Check the connection.
Check cartridge install.
Check valve position.
Check any impurities. Remove all impurities.
Open it to full valve
When packing is damaged, replace the cartridge.
Check the existence of packing and wind it up sufficiently
Poor flow rate
Leakage
Water supply valve
Flexible hose
Aerator
Check if hose is twisted.
Check if the water from Supply valve is enough or not
Check if the supply pipe connected correct or not Connect the hot and cold water pipe correctly
Increase water supply
Deviant
Temperature
Supply Valve
Trouble
Checkpoint
Contents Action
Supply system
Care & Maintenance
* If you want to change the parts
or clean the inner of faucet,
please follow the steps in the
above to remove the parts,
then proceed the next steps.
Attention:
Please leave the manual with the customer
after installation is finished.
Aerator
Clean Water
Remove all impurity in Aerator
Soft Brush
Installation &
Operation Instructions
* Recommended water pressure condition: 0.1~0.5Mpa.
* Environment Temperature:1~55℃
* Steam is not allowed to use.
* The cold and hot water pipes must not be reserved.
Conditions for use
*Remove all impurity in pipes before beginning to avoid clogging. Connect faucet pipes correctly.
* Check installation distances in the Dimension diagram to ensure correct installation.
Make sure the cold water hose
is connected to the right side and the hot water hose to the left.
When in the process of installation, grab the whole body. Do not grab handle only.
Pre-Installation Checks
* American Standard always keep raising and improving the product design and performance, and reserve the right to modify
the dimension and spefication. At this case, we will not inform you separately.
* This installation instruction sheet is for your reference only, the dimension and specification is subject to the actual products.
Thank you for selecting American-Standard - the benchmark of fine quality for over 100 years.
To ensure that your installation proceeds smoothly--please read these instructions carefully before you begin.
All instruction procedures must comply in strict accordance with applicable local plumbing and building codes
Recommended Tools and Materials
Electric drill
Pencil
windtight swathe
Adjustable Wrench Level Tape Measure
Screwdriver Sinker
Dimension
FFAS0711-601500BF0
2.5mm
FFAS0712-701500BF0

- 2 - - 3 -
Installation
Installing the S-Connector
1
1
Installing the Faucet
2
3
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
Index Button
Screw
Handle
Cap
Nut
Cartridge
Diverter Valve
Body
Nut
O-Ring
Screw
Washer
Escutcheon
S-Connector
Aerator
Hose
Screw
Shower Hanger
Shower
Body
1
1
1
1
1
1
1
1
2
2
2
2
2
2
1
1
1
1
1
0
FFAS0711 / FFAS0712
35~40
150
2
（Cold）
（Hot）
S-Connector
Finished Wall
Escutcheon
Washer
Nut
Faucet
2
1
3
30
3
2
4
Screw
1
2
5
6
1
3
4
5
67
98
10
11
12
13
14 15
16
17
18
19
20
1
1
1
1
1
1
0
0
2
2
2
2
2
2
0
1
1
1
1
1
* Consult the dimension
drawing and lay the pipes.
* Wash and clean the
water supply pipeline.
Anchor
Shower Hanger
Installing the Shower Hanger & Hose
S-Connector
Water Supply
Pipeline (Hot)
Water Supply
Pipeline (Cold)
Parts List
No. Part Name Q’ty
Parts List
Level