Guide to Installation
Connect the cable
www.ampereselectronics.com
Introduction
Mark the screw mounting hole.
Mark the screw position properly, follow the template provided.
Mounting speaker to ceiling
CS516 is a general purpose ceiling surface mount speaker, suitable for slab
mounting. Its dual cone driver delivers good sound reproduction for speech and
background music.
Precision Design, absolute Confidence Instruction Manual
CS516 Surface Mount Ceiling Speaker
5” 6W 100V Surface Mount Ceiling Speaker
ISO 9001: 2015
Design & Manufacture of Public Address Equipment and Systems
M4 Screw Hole
M4 Screw Hole
75 mm 111 mm
M4 Screw Hole
Ceiling
Cable from PA rack
Connect the cable terminal to the speaker cables according to the
required power rating. Terminate the incoming speaker cable to
the selected transformer primary cable using a connector.
Speaker
Speaker cable (in conduit)
Ceiling
Termination box
Speaker
Speaker cable (in conduit)
Remove the honeycomb grille by turning clockwise. Thereafter
mount the speaker to the ceiling and fasten properly to secure the
unit.
Screw
Wall plug
Ceiling
Installing the grille to complete the installation.
Cable Termination
Yellow
Green
Black
1.5W
6W
3W
Red
COM
Speaker cable Black
Yellow
Green
Red Termination box
100V Line
From Amplifier
output
Connect either the Red, Yellow or Green
wire to the terminal box, depend on the
desired power ratings.
Attach the speaker grille to the body by turning anti clock wise
The installation is complete as shown.
Tools for installation
3 pcs x Wall Plug
3 pcs x screw for install speaker to ceiling
Recommended size for screw : Diameter Length
1) Screw M4 30mm
2) Wall Plug 6mm 30mm
Note: Parts not supplied in package.
Termination box
